2) Counter pressure
径向反压
3) neck-spinning
缩径旋压
1.
Finite element numerical simulation and experimental research on the forming force of mandreless neck-spinning with single roller;
无芯模缩径旋压力的有限元数值模拟及试验研究
2.
Defection and process study on thin-wall aluminum tube neck-spinning;
铝合金薄壁管缩径旋压成形缺陷及工艺分析
3.
The study on the numerical simulation of non-axisymmetric tube neck-spinning and process parameters optimization;
非轴对称管件缩径旋压的数值模拟与参数优化的研究
4) diametrical compression
对径压缩
5) push-sinking
推压缩径
1.
Analysis of buckling in push-sinking and lts lnfluence factor;
管坯推压缩径端部翘曲机理及其影响因素分析
6) radial extrusion
径向挤压
1.
Technical Study of Radial Extrusion Forming on the Super-Long Odd Shafts based on Multiple Directions Extrusion
基于多向挤压的超长异形轴径向挤压工艺研究
2.
The radial extrusion technological process of the internal thread spline was studied and a set of extrusion mould suitable for the forming of the internal thread spline in the guide bush.
以汽车单向器导向筒内螺旋花键为研制对象 ,对内螺旋花键的径向挤压工艺进行了研究 ,设计了1副适合于导向筒内螺旋花键径向成形的挤压模。
3.
The warm radial extrusion of internal ring with inclined groove is introduced in this paper.
介绍了斜槽内环零件的温径向挤压工艺及三瓣模的设计、模具结构及主要零件的设计及选材。
补充资料：径径
1.不停貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条