1) PE Casting Porous Film
PE流延打孔膜
2) PE perforated film
打孔膜
1.
Non-poisonous, wide range and high efficiency bacteriostatic, good heat-resistant inorganic antibacterial agent containing silver was used for preparation of antibacterial masterbatches for PE perforated film by melt extrusion with PE plastic.
将无毒、抗菌谱广、抗菌效率高、热稳定性好的载银无机抗菌剂与PE熔融挤出制备了打孔膜用抗菌母粒,研究了抗菌母粒的添加对打孔膜的抗菌性能、光老化性能、安全卫生性能的影响。
3) hole-ground film
地膜打孔
4) PE film
PE膜
1.
The acrylic acid (AA) was grafted onto the PE film surface through UV photograft polymerization.
通过紫外光接枝聚合反应 ,将丙烯酸 (AA)接枝于PE膜表面 ,在一定 pH值条件下 ,使接枝膜与Eu3+、α 噻吩甲酰三氟丙酮 (TTA)的乙醇 水溶液或Tb3+、乙酰丙酮 (AcAc)的氯仿 水溶液作用 ,制得红色或绿色荧光膜。
2.
When PE film is firstly treated with solution of photo initiator, and then photo grafting se-quentially in monomer water solution, the processing of liquid phase surface photo-grafting is to beimproved.
采用预先以光引发剂溶液处理PE膜，然后在单体水溶液中进行光接枝反应的方法，对液相表面光接枝工艺做了改进。
5) jet holing
射流打孔
6) cast film
流延膜
1.
6°,higher than the contact angle between cast film and water 107.
6°,高于PLA流延膜与水的接触角107。
2.
A kind of cast film speciality polypropylene(PP) resin was purposely developed in accordance with the characteristics of the existing PP production plant and the actual demand in domestic market.
经加工厂家应用表明,该树脂能满足进口流延膜生产线的高速加工。
3.
Controlling of processing parameters such as temperature and draw velocity in film casting process was discussed, the demands of raw materials and problem incurred in manufacturing process of cast film were reviewed.
介绍了聚丙烯流延膜的性能和应用情况,讨论了聚丙烯流延过程中温度和拉伸速度等工艺因素的控制,并结合多层共挤膜中各层的作用提出了聚丙烯流延膜对原料的要求,以及加工过程中存在的主要问题。
补充资料：打流
1.方言。犹流浪。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条