说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 测试资料解释
1)  testing data interpretation
测试资料解释
2)  well test data interpretation
地层测试资料解释
3)  DST interpretation
中途测试资料解释
4)  interpretation of electrical sounding material
电测深资料解释
5)  data interpretation
资料解释
1.
Application of fuzzy pattern recognition to transient electromagnetic data interpretation;
模糊模式识别在瞬变电磁测深资料解释中的应用
2.
Testing principle of the technology, testing technology and data interpretation method are introduced.
介绍了该技术的测试原理、测井工艺以及资料解释方法。
3.
For many procedures and factors which influence testing results, to find sticking point by analyzing the main factors from objective and subjective aspects for completing field procedure and data interpretation process which improves well testing tech and interpreting level.
随着测试技术的发展、测试质量及资料解释水平的提高,测试(试井)成果的可靠程度越来越受到重视。
6)  interpretation [英][ɪn,tɜ:prɪ'teɪʃn]  [美][ɪn'tɝprɪ'teʃən]
资料解释
1.
Utilizing the quick-look of radioactive correlation flowrate logging and quantifying the uncertainties in isotopic tracing logging,the aims of improving the logging success rate and interpretation accurate are achieved.
应用放射性相关流量测井的直观性,量化同位素示踪测井中的不确定因素,达到提高测井成功率和资料解释精度的目的。
2.
The current methods of 3D seismic data interpretation are based on 2D seismic data interpretation methods.
目前的三维地震资料解释方法仍停留在二维解释的基础上。
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条