1) error calculation
误差计算
1.
The problems for attention in error calculation and judgement are analyzed to ensure the accuracy of bridge testing.
介绍携带型直流电桥整体检定,分析直流电桥误差计算和判断中应注意的问题,保证了电桥检定的准确度。
2.
A statistical method was proposed for the error calculation of full width at half maximum (FWHM) of X-ray diffraction peaks from the "Strip-chart" diffractometer, while formulas describing the relations a-mong the intensity, shape and measuring conditions were used for that of "Digital" diffraction peaks.
提出的原理及公式,不仅适合半高宽的误差计算,也适合于其他衍射参数的分析计算,并可用于数字化光谱分析计算中。
2) calculation errors
计算误差
1.
The influence of the maximum deviation angle θ max in the kinetic model on the interface shape and calculation errors is vestigated.
讨论了界面动力学模型中的最大偏移角θmax对小面的形状和计算误差的影响 ,给出了一种十分有效地降低计算误差的措施 :在模型方程中适当计入表面张力的影响。
3) calculation error
计算误差
1.
The additional calculation error of measuring gas flow capacity through planimeter calculating av- erage value between differential pressure and static pressure with dual bellows differential pressure flow capacity table is discugsed in this paper.
本文讨论了从双波纹管差压流量卡片上,用求积仪求得差压和静压的平均值计算天然气流量方法所产生的附加计算误差;分析了差压和静压在不同的变化趋势下,附加计算误差的大小和方向;提出了改进和预防的建议。
2.
Adopt this method to construct an arbitrary sinusoidal signal which has the same frequency as the reference signal,use this sinusoidal signal to replace the reference signal,then the calculation error induced by the distortion of the reference signal can be eliminated.
采用该方法构造任意一个与参考信号同频率的正弦信号,用构造的正弦信号代替参考信号,可以消除参考信号畸变导致的计算误差。
3.
The calculation error in predicting brake power increases with increasing engine speed and decreases with increasing pressure.
轴功率的计算误差随着转速的增加而增大,随着压力的增加而减小。
4) calculating error
计算误差
1.
In this paper a theoretical analysis was made about calculating errors by using the general fomula de- rived from reference [1],in comparision with practical examples.
本文从理论上对参考文献[1]中导出的运动误差分析通用公式的计算误差进行了分析,并通过实例加以比较,指出了应用该通用公式对平面低副机构运动误差进行分析有足够的计算精确度,完全能够满足实际工程的需要。
2.
The calculating error of the maximum nondistortion output power and its causes in the OTL circuit is discussed in this paper,and the amendament pasameter and calculat- ing formula is given.
本文分析了复合互补 OTL 电路最大不失真输出功率的计算误差、误差产生的原因,提出了计算误差的修正系数并推导了计算公式。
5) computation error
计算误差
1.
Several problems such as computation error and image restoring,are also discussed and solutions are provided.
为了保护信息,防止信息遗失或泄密,提出了一种空域和变换域相结合的基于关键区域的彩色图像水印算法,应用于彩色静止图像,讨论了计算误差和图像复原等问题,并给出了解决方法。
6) computational error
计算误差
1.
By a comparison of the result with that of the analytical solution, the computational error of the numerical solution is discussed.
进行数值求解，通过数值解与精确解的比较，对计算误差的变化规律进行了分析研究。
补充资料：计算误差
分子式：
CAS号：
性质：在计算过程中，由于将复杂的表达式以近似式代替，或由于数字修约而产生的误差。
CAS号：
性质：在计算过程中，由于将复杂的表达式以近似式代替，或由于数字修约而产生的误差。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条