1) thin furnace lining
薄炉衬
1.
3 BF,some measures adopted during smelting totally with coke at the initial stage of starting-up and operation practices adjusting at the top and bottom after starting-up,draws temperature standard for copper cooling stave zone,points out retaining suitable coal gas flow at the edge and temperature at middle limitation are the keys to strengthen smelting for BF with thin furnace lining.
介绍了鞍钢新3号高炉铜冷却壁特点、开炉初期全焦冶炼过程采取的一些措施以及开炉以后上下部调剂的操作经验,并制定出铜冷却壁区域温度标准,提出保持适当的边缘煤气流以及中限炉温是薄炉衬结构高炉强化冶炼的关键。
2.
In order to reaching the aim of long campaign,imported ceramic cups are used for furnace bot- tom and hearth while thin furnace lining and copper cooling stave are adopted at bosh,belly and lower part of stack.
为了实现长寿目标,高炉炉底、炉缸采用进口陶瓷杯,炉腹、炉腰和炉身下部选用薄炉衬和铜冷却壁,本体和热风炉的冷却全部采用软水。
2) thin skinned lining
薄壁炉衬
1.
A series of advanced and suitable techniques were adopted in the design of 1750m3 BF in Jigang, such as entire cooling staves structure, thin skinned lining, copper cooling staves, carbon brick-ceramic cup complex bottom, closed loop soft water cooling system, PW serial type bell-less top with two coaxial vertical hoppers, KALUGIN top-combustion stove, etc.
济钢1750m3高炉设计采用全冷却壁、砖壁合一薄壁炉衬、铜冷却壁、碳砖-陶瓷杯复合炉底、全软水密闭循环冷却系统、PW串罐无料钟炉顶、KALUGIN顶燃式热风炉等一系列先进实用技术,为实现高产、优质、低耗、长寿、环保的生产目标奠定了技术基础。
2.
7 blast furnace o Benxi Steel,such as entire cooling staves structure,thin skinned lining,copper cooling staves,UCAR carbon brick cerami(?) cup complex bottom,closed loop soft water cooling system,PW serial type bell less top with two coaxial vertical hoppers Hoogovens top-combustion stove,etc.
本铡7号高炉(2850m~3)设计采用全冷却壁、砖壁合一薄壁炉衬、铜冷却壁、UCAR 炭砖-陶瓷杯复合炉底、全软水密闭循环冷却系统、PW 串罐无料钟炉顶、Hoogovens 内燃式热风炉等一系列先进实用技术,为实现高产、优质、低耗、长寿、环保的生产目标奠定了技术基础。
3) furnace lining
炉衬
1.
The analysis of corrosion of electric furnace lining for the production of phosphorus;
制磷电炉炉衬的腐蚀环境分析
2.
Kinetics Influence of Oxygen Releasing from Furnace Lining on Removal of Nitrogen in Steel during Vacuum Smelting;
炉衬产生的氧对真空钢液脱氮的动力学影响
3.
Pilot study on magnesium removal using sulphric acid from copper-smelting furnace lining waste magnesia brick;
铜冶炼炉炉衬废镁砖硫酸脱镁试验研究
4) liner
[英]['laɪnə(r)] [美]['laɪnɚ]
炉衬
1.
It discusses how to prolong life of refinery furnace liner with ramming material.
论述了延长精炼电炉捣打料炉衬寿命的问题。
2.
The general situation of induction smelting furnace mould liner at home and abroad,quality demands about refractory material of mould liner are introduced in this paper.
介绍了感应熔炼电炉成型炉衬的国内外概况和对耐火材料的质量要求,研究了镁砂质碱性炉衬耐火材料的骨料粒度分布、骨料与细粉(基质)、氧化铝微粉、结合剂、缓凝剂、加水量以及烧结剂对耐火材料体积密度、强度及烧结点等性能的影响。
3.
The campaign of induction furnace is lower because 10t main frequency furnace uses of acid refractory liner that is corroded by liquid iron and basic slag under the working condition of high temperature and full load and abraded in the process of charging cold burden.
10t工频感应炉炉衬原采用酸性耐火材料,在高温满负荷工作状态下,受铁液及碱性炉渣侵蚀,加冷料过程中受机械磨损,造成感应炉炉龄低。
5) lining
[英]['laɪnɪŋ] [美]['laɪnɪŋ]
炉衬
1.
Principles of design for blast furnace refractory lining and application of the Ceramic Cup;
高炉耐火炉衬设计原则及“陶瓷杯”的应用
6) furnace liner
炉衬
1.
Base on the using condition of my company,It was thought that the choosing compatible material of furnace liner,the building of furnace liner,and the roasting and the repairing in time is vital to prolong the using life.
针对中频感应电炉炉龄短长期制约生产的突出问题,分析了作者所在公司多年来生产使用情况,经实践认为,选择合适的炉衬材料、炉衬的打筑、烘烤及使用过程中的及时修补等是提高炉龄的关键。
2.
Substitution of complex refractory fiber furnace liner for heavy refractory furnace liner in oilfired multiplehearth was reported.
本文着重介绍了耐火纤维炉衬代替原燃油多罐井式热处理炉重质耐火炉衬的使用情况。
3.
With different kinds of furnace linersand a resistant measuring device made by ourselves,the relations among surface roughness,the distribution and the thickness of fluidizating dead zone near the surface were got.
就细颗粒流化床的炉衬表面粗糙度对（准）散式流化状态的影响进行了试验研究。
补充资料：炉衬
furnacelining：高炉炉衬组成高炉的工作空间，并起到减少高炉热损失、保护炉壳和其它金属结构免受热应力和化学侵蚀的作用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条