1) Ti6Al4V/TA1 diffusion couple
Ti6Al4V/TA1扩散偶
1.
Ti6Al4V/TA1 diffusion couples were fabricated and then heat-treated in vacuum under different conditions.
通过Ti6Al4V/TA1扩散偶的制备及其热处理试验,运用OPM,SEM以及EDS技术对扩散连接区域的组织、形貌、成分进行分析。
2) diffusion triple
扩散偶
1.
The isothermal section of Fe-Ni-Nb ternary system at 1198 K was determined by means of diffusion triple and electron microprobe analysis, a serials of the relative phase were investigated.
采用扩散偶技术测定了Fe-Ni-Nb三元系1198K的等温截面,借助电子探针微区成分分析方法对Fe-Ni-Nb三元扩散偶的相区成分,及相关系进行研究。
2.
The isothermal section of Fe-Co-Nb ternary system at 1173 K was determined by means of the diffusion triple and electron microprobe analysis.
根据扩散偶局部平衡原理,用电子探针微区成分分析,测定了Fe-Co-Nb三元系1173 K的等温截面相图。
3.
The isothermal section and the components of the phase regions for Ni-Mo-Re ternary system at 1473 K was determined by means of diffusion triple and electron microprobe analysis.
采用三元扩散偶技术测定了Ni-Mo-Re三元系1473K的等温截面,借助电子探针微区成分分析方法分析了Ni-Mo-Re三元扩散偶的相区成分,并对其相关系进行了研究。
3) diffusion couple
扩散偶
1.
Experimental study on interface of Al/Cu diffusion couple;
Al/Cu扩散偶相界面的实验研究
2.
Interfacial reactions between Sn liquid and Ni substrate using Sn/Ni liquid/solid diffusion couple;
Sn/Ni液/固扩散偶的界面反应
3.
Growth of intermetallic compounds in solid Zn/Fe and Zn/Fe-Si diffusion couples;
Zn/Fe及Zn/Fe-Si固态扩散偶中金属间化合物的生长
4) diffusion couple technique
扩散偶法
5) diffusion couples
扩散偶
1.
Study on distribution ratio of Co and Ti in Fe-Ni-Al based solid solution α_1 and α_2 by diffusion couples;
Co和Ti在Fe-Ni-Al基固溶体α_1/α_2间分配比的扩散偶法研究
2.
The local phase equilibrium principle is recommended as well as the outline of the method of diffusion couples in determining the equilibrium phase diagram.
介绍了局域平衡原理和扩散偶法测定平衡相图的方法要点。
3.
The mechanism of chemical reaction was studied by the diffusion couples of Ti-B4C.
５ｈ后的物相组成，通过Ｔｉ－Ｂ４Ｃ扩散偶对反应机理进行了研究，实验结果表明在反应过程中扩散路径是：Ｔｉ／ＴｉＣ／ＴｉＢ／ＴｉＢ２／Ｂ４Ｃ，在扩散偶中Ｔｉ与Ｂ４Ｃ作为反应相始终存在，生成物中 ＴｉＢ２， ＴｉＢ和 ＴｉＣ三相同时存在，而对于粉料烧结后只有 ＴｉＢ２和ＴｉＣ两相。
补充资料：TC4(Ti6Al4V)焊接组织
TC4(Ti6Al4V)焊接组织
719
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条