说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 故障率
1)  failure rate
故障率
1.
Improving control system reliability and reducing overflow weir failure rate;
加强控制系统可靠性 降低溢流堰故障率
2.
The method of reducing failure rate for measuring bearing liner temperature in DAS system of 300MW turbine set;
降低300MW汽轮机组DAS系统轴瓦温度测点故障率
3.
The influence on failure rate by applying grain temperature measurement system;
粮食测温系统结构及技术应用对故障率的影响
2)  Fault rate
故障率
1.
The system fault rate and reliability mutative law with the life are predicted by the analysis of a sample of invalidation time.
利用Monte Carlo系统仿真方法,对火灾探测报警系统失效时间进行抽样,模拟分析了系统可靠度和故障率随时间的变化规律,得到的可靠度和故障率曲线符合理论和工程实践。
2.
The cause of unreliable factor producing was analyzed from many aspects such as instrument equipments management,fault rate,maintenance and maintaining.
从仪器设备的管理、故障率、维修及保养等多个方面,分析研究了不可靠因素产生的原因,提出了避免和减少不可靠因素,增强仪器设备使用可靠性的方法与措施。
3.
The mathematic method of least square theory is proposed to obtain the fault rate of overhead lines in distribution system,i.
提出了用数学的方法——最小二乘法的拟合来求取配电系统中架空线路的故障率,即用某一个特定的物理量(自变量)去描述暴风天气、暴雨天气、冰雪天气、高温天气、地基等影响因素,则线路故障率(因变量)可以表示成关于各个因素物理量的函数。
3)  Malfunction rate
故障率
1.
Rule Malfunction Rate and Maintaining Tactics of Weapon Equipments;
武器装备故障率规律与维修策略研究
2.
The malfunction rate curve of weapon equipment and its characteristics are introduced.
论述了武器装备故障率曲线的特点,分析了几种维修模式的优缺点,提出了应用ABC法对重点关键装备应采用标准维修或状态维修的方式,而其它装备应根据装备的故障信息统计结果,采用相应的方式。
3.
Based on the logical flow diagram,this paper calculates the reliability of the 110kV main connections in Tianji Group and gets both the reliability and malfunction rate at each 6kV load point, which will provide a reference for the operating and maintaining of this power supply system.
用逻辑流图法对天脊集团 110kV主线接线进行了可靠性计算 ,得出各 6kV负荷点的可靠度及故障率 ,为系统运行及检修提供参考性依
4)  fault frequency
故障频率
1.
Based on the GSPN model,through calculating the probability of two nodes\' connectivity,using parameters such as node\'s transmission range,average number of neighbors and fault frequency,the survivability was analyzed.
在此基础上,通过计算两个节点连通的概率,利用节点传输范围、节点平均邻居数目和故障频率这些参数,对网络的可生存性进行了分析,其分析结果对选取适当的节点传输范围或节点平均邻居数目有参考价值。
5)  fault probability
故障概率
1.
Robust information sharing scheme for federated filter based on fault probability;
基于故障概率的联邦滤波鲁棒信息分配方法
2.
In this paper,the reliability of industry control-network with different structures are analyzed based on modeling the fault probability.
通过建立系统网络故障概率模型,比较总线型控制网络在不同结构下的故障概率,并给出了分级模式和分段模式两种网络系统示例的分析结果。
3.
An efficient method for computing the fault probability of network systems is presented.
从而可通过各故障模式的故障概率和故障模式之间的相关度综合确定系统的故障概率或可靠度。
6)  heat-failure
热故障率
1.
Therefore their heat-failure can be reduced.
实验结果表明,涂有201BT材料的接头表面散热量增加,表面温度得到抑制,因而达到了降低热故障率的目的。
补充资料:电导率(见电阻率)


电导率(见电阻率)
conductivity

d!日nd日O}已电导率(eonduetivity)见电阻率。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条