1) biting condition
咬入条件
1.
Analysis of biting condition in radial-axial ring rolling;
环件径轴向轧制的咬入条件分析
2) biting
[英]['baɪtɪŋ] [美]['baɪtɪŋ]
轧辊咬入轧件
3) biting
[英]['baɪtɪŋ] [美]['baɪtɪŋ]
咬入
1.
Based on the analysis of the change in torque during plate rolling with respect to each pass reduction,it is known that the peak torque occurring in the biting phase of workpiece head is the key factor to restrain the pass reduction.
分析扭振在道次轧制中的变化特点,得知头部咬入阶段的峰值扭矩是制约道次压下量的关键因素。
4) Inlet condition
入口条件
1.
Most-unstable wave method for inlet conditions of large eddy simulations of spatially developing channel flows;
获得空间发展槽道流动大涡模拟入口条件的最不稳定波方法
5) suction condition
吸入条件
1.
On the basis of compared and analytical results of all sorts of pumps, the suction condition of self-sucking sliding-vane pump is described.
在与各类泵对比分析的基础上,论述了滑片自吸泵的吸入条件,指出滑片自吸泵吸入装置必须满足吸入能力的要求。
6) qualification of fishing
入渔条件
补充资料：咬入条件
咬入条件
bitting condition
yaoru tiaojian咬人条件(bitting eondition)轧件前端与轧棍接触时，轧辊把轧件拉入辊缝进行轧制所必须具备的条件。当轧件与轧辊接触时，轧辊作用在轧件上一于布 轧件咬入时作用力图个正压力尸和摩擦力T(见图);按库仑摩擦定律，力p和力T与摩擦系数f有以下关系:粤一f或T一一”’z寸一J~胡、门、~2曰~”了、司、’PJ~‘fP。显然，尸和T的水平分量尸二和T二是直接影响轧件咬入的因素，因尸，是阻止轧件进入变形区的力，T二是将轧件拉入变形区的力。只有当T:>尸二时轧件才能被咬入，T二~尸二是临界条件，T二<尸二则不能咬入。所以从力学条件看，实现轧件咬入必须满足T二)尸二即尸sina镇Tcosa或T/P簇tan口。由于摩擦系数f一T/尸和f~tan夕，夕为摩擦角，故咬入条件的最终形式也可表示为少奋tana或夕)a。 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条