1) overaging
['əuvə'reidʒiŋ]
过时效
1.
A Study on Temper Embrittlement Overaging Phenomenon of Alloy Steel 2.25Cr-1Mo;
2.25Cr-1Mo合金钢回火脆化过时效现象的研究
2.
The recrystallization,austenization and overaging of cold rolled strip during continuous annealing were investigated by optical microscopy and scanning electron microscopy.
采用光学显微镜与扫描电镜观察分析了实验钢冷轧组织在连续退火过程中的再结晶与相变规律,研究了过时效回火对双相钢显微组织的影响。
2) over ageing
过时效
1.
The effect of over ageing (OA) and temper rolling on the mechanical properties of cold rolled low carbon SiMn dual phase steel sheets has been studied.
以低碳Si Mn系冷轧双相钢为研究对象,探讨了过时效和平整工艺对双相钢板力学性能的影响。
2.
Effect of over ageing on the mechanical properties and microstructure of Si Mn dual phase steel sheets was studied.
研究过时效温度和时间对低碳Si Mn冷轧双相钢的力学性能和组织的影响 ,结果发现 ,过时效温度对双相钢力学性能影响很大。
3) over-aging
过时效
1.
The research focused on analyzing the effect of over-aging temperature on the mechanical properties and microstructure of super high strength mild cold-rolled dual phase steel.
研究了过时效温度(室温～500℃)对超高强低碳冷轧双相钢力学性能的影响。
4) over-aged
过时效态
1.
Fatigue behavior of over-aged 2A12 alloys in a vacuum environment;
真空环境下过时效态2A12合金的疲劳行为
5) Aging process
时效过程
1.
Effects of Al5TiB on aging process of Mg-8Zn-4Al-0.3Mn alloys;
Al5TiB对Mg-8Zn-4Al-0.3Mn合金时效过程的影响
2.
In this paper the effect of Cu and Mg on the aging process of Al - Si - Cu - Mg cast alloy have been investigated.
本文研究了Cu和Mg对铸造Al—Si—Cu—Mg合金时效过程中的影响,DSC和TEM实验发现,合金的时效硬化现象与强化相的析出序列密切相关,Al—Si—Mg三元合金中,GPⅡ区和亚稳相的形成重合交叉进行,GPⅡ区(β″)向亚稳相(β′)的转变没有明显的时间间隔,导致时效硬化曲线上出现硬度平台。
6) overheat aging
过热时效
1.
The overheat aging have been investigated for Cu-26.
4 Zn-4 Al 工程元件做了过热时效效应实验,观察了记忆合金在不同时效温度下,显微图像中可逆马氏体和母相等微观组织的变化。
补充资料：过时效
overaging：与获得最佳力学性能（强度和硬度）的时效处理条件相比，过时效是指在温度过高或时间过长条件下发生的时效现象。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条