1) swing angle of cage chair
摇台摆角
1.
Calculation on the swing angle of cage chair of machine tool when cutting spiral bevel gear;
切制弧齿锥齿轮时机床摇台摆角的计算
2) Right-angle Three-cylinder Hydraulic Platform
直角三缸液压摇摆台
1.
Under laboratorial environment , Right-angle Three- cylinder Hydraulic Platform is a empirical equipment that simulates vibration warship and movement of the warship on the water surface, it can accomplish carrier plane illuminated guidance performance test of the system.
直角三缸液压摇摆台是在实验室环境下模拟舰船在水中的摇摆和运动的一种实验设备,可以在实验室完成舰船上舰载飞机灯光导引系统的性能实验。
3) Swing bench
摇摆台
1.
Simulation study on the swing bench control of anti-rolling tank based on IGA-PID
基于IGA-PID的减摇水舱摇摆台控制仿真研究
4) rocking angle
摇摆角
1.
In the design of transmission line,the rocking angle critical curve is calculated based on the maximum rocking angle in the circumstances all kinds of operation,and the poles and towers check on safe distance is analyzed in the light of curve.
为提高输电线路定位速度和质量,以东路—官塘220 kV送电线路工程为例,论述在输电线路定位设计中,根据杆塔在各种运行情况下的最大允许摇摆角,作出其摇摆角临界曲线,然后按照曲线对杆塔逐基进行电气安全距离检查。
5) swinging angle of rocker
摇杆摆角
1.
included angle of extreme positions θ) and swinging angle of rocker ψ,and by means of introducing the positional angle of the fixed hinge of crank,the explicit functional relationship of θ and ψ with regard to crank,connecting-rod and length of machine frame was established.
根据曲柄摇杆机构的行程速比系数K(即极位夹角θ)和摇杆摆角ψ,通过引入曲柄固定铰链点的位置角,建立了曲柄、连杆和机架长度关于θ和ψ的显式函数关系;在此基础上,研究了机构设计的可能附加要求及其相应的设计方法,为曲柄摇杆的设计提供了各种可能选项;进而分析了各种附加要求必须满足的条件,以确保该机构存在且可用。
补充资料：摆龊
1.犹密布。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条