1) qualified rate
合格率
1.
Analysis of influence causes on qualified rate of defects detection of tyre;
影响轮箍探伤合格率的原因分析
2.
Influential factors analysis on detection qualified rate of food samples;
影响食品样品检测合格率因素的探讨
3.
Several suggestions about improving the corrosion qualified rate of strain gauge;
有关提高应变计腐蚀合格率的几点建议
2) qualification rate
合格率
1.
Discussion on improving the qualification rate of R03P battery for the first time;
提高R03P电池一次合格率的探讨
2.
According to packaging types,the qualification rate in packaged products was 96.
96份肉制品检测结果表明,火腿肠、罐头产品中亚硝酸盐的残留量合格率为100%,风干肠类、酱卤类、烤肠类合格率为71%~87%。
3.
One -turn -qualification rate for binocular is raised effectively by taking corresponding measures.
阐述了双筒望远镜涂装的质量现状,用排列图和因果图查找了出现质量问题的原因,采取相应措施有效地提高了双筒望远镜喷漆的一次合格率。
3) percent of pass
合格率
1.
Analysis and predicte the disinfection percent of pass for endoscope
消毒级内窥镜的消毒合格率分析与预测
2.
The measures to improve the percent of pass of aging property were obtained,such as micro-Ti treatment and finishing rolling temperature control.
介绍了济钢 2 0g钢进行时效性能合格率试验的情况 ,得出采用微钛处理和控制终轧温度可有效提高 2 0 g钢时效性能合格率 ;将试验结果用于工业生产 ,可使厚 10～ 2 0mm钢板的时效性能合格率由 60 %左右提高至 94%以上。
3.
The effect of smelting SiCr by dualprocess to percent of pass for export is analysed.
分析了二步法冶炼特种硅铬合金工艺对其出口合格率的影响因素；着重介绍了硅铬合金冶炼工艺的改进及其效果。
4) Pass rate
合格率
1.
This paper uses K-Means Cluster analysis to analyze the key indicators in the pass rate of the CPA examination in the 2003 in China,analyzes the indicators in the other eight provinces by means of discrimi- nate method,and finally defines the four categories of zones which is the pass rate of the CPA examination distribution in China.
运用快速聚类方法对我国各个省份2003年度注册会计师考试合格率的主要指标进行聚类分析,然后再对其中8个没有参加聚类分析的省份进行判别分析,最终确定我国注册会计师考试合格率地区分布的4类区域,从而观察到合格率的地区分布情况与各省份的经济情况存在着一定的联系。
2.
For the dimensional quality evaluation of complex mechanical products based on small sample, an empirical Bayesian infer algorithm for pass rate estimation was provided, which took full advantages of the historical inspection data and the information of current sample.
针对复杂机械产品制造业广泛存在的大批量生产、小样本检测的特点 ,在采用矩法由历史测量数据构造产品合格率参数先验分布的基础上 ,提出一种综合历史数据与当前小样本信息进行合格率估计的 Bayes算法 ,建立了动态递推模型 ,实现了合格率的准确估计 。
5) yield
[英][ji:ld] [美][jild]
合格率
1.
TV Glass Panel Yield and the Quality Cost Optimization;
玻壳合格率及质量成本对策
2.
Increase of the Insulation Yield of Stripping Capacitance and Metallizing Polycarbonate Film Capacitors;
提高剥容的金属化聚碳酸酯薄膜电容器的绝缘合格率
3.
Through adjustment of the width of the slot plus using turning process instead of milling process for bur removal with the addition of proper inspection method,for upgrading the quality of the joining parts,consequently avoiding fiber burring,yield going up from 92% to 99%.
分析了造成分梳辊体结合件挂花的原因,通过在实际中调整分梳辊辊体槽宽尺寸,改铣槽工艺为车槽工艺,增加去毛刺工序以及制定明确的检验方法来改进分梳辊体结合件加工质量,最终使其不挂花合格率由原来的92%提高到99%。
6) Acceptance rate
合格率
1.
Probabilistic analysis and reliability assessment for acceptance rate of foundation pile testing
基桩检测合格率的概率分析及可靠度评估
2.
By strictly controlling the composition,temperature,and flowability of the molten steel produced with a 150 t LF refining furnace at Tang Steel for subsequent cold rolling,the acceptance rate of the refined steel was markedly increased from 70% to above 98%.
唐钢150 t LF(lad le furnace))精炼炉通过对冷轧用钢成分、温度、可浇性的合理控制,精炼合格率由原来的70%提高到98%以上。
补充资料：污染物综合排放合格率
污染物综合排放合格率
qualification ratio for integrated discharge of pollutant
wuranwu zonghe Paifong hegelU污染物综合排放合格率(qualifieation ratiofor integrated diseharge of pollutant)排放合格的污染因子项目数与全部污染因子项目数之比的百分率，是环境保护考核指标之一。其数学计算公式为: 尸一豁丫10。% N，一艺尹 J=1 N一艺关 了~1式中尸为企业污染物综合排放合格率，%;N‘为企业主要污染物的主要污染因子排放合格的总项目数;入为企业主要污染物的主要污染因子的总项目数;i为主要污染源序号;n为主要污染源的项目数;尹为第i项污染源中主要污染因子合格的项目数;工为第i项污染源中主要污染因子的项目数。 中国冶金企业主要污染源和主要污染因子的制定，根据冶金工业部的污染因子统一项目表所规定的项目范围，结合本企业的实际情况，按工厂、车间、工段和生产设施逐一列出，并报请上一级机关审定。经审定的项目，即作为冶金工业部对该企业进行环境保护考核的依据。 污染物综合排放合格率计划指标，按年度生产技术财务计划编审程序编报和审批，按冶金工业部统一规定的各项污染因子的排放指标考核，每季度计算一次，每年度考核一次。其计算数据均以该企业环境保护监测站向上级报告的监测数据为依据。 污染物综合排放合格率是冶金工业部考核企业环境保护工作的一项综合性指标，1984年纳人冶金企业清洁工厂(矿山)标准，1991年又纳人冶金企业晋级环境保护考核标准。 (魏宗华)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条