1) Salt spray corrosion
盐雾腐蚀
1.
Study on salt spray corrosion of the paint coating containing flaky Zn-15Al-5Mg-Ce alloy
鳞片状Zn-15Al-5Mg-Ce合金油漆涂层的盐雾腐蚀研究
2.
The influence of salt spray corrosion on high-temperature cyclic oxidation behavior of thermal barrier coatings(TBCs) prepared by electron beam physical vapor deposition(EB-PVD) have been investigated.
研究了常温盐雾腐蚀对其循环氧化行为的影响。
2) salt spray test
盐雾腐蚀
1.
The results show that the resisting salt spray corrosion time of the microwires is above 240 h in neutral salt spray test;the average breakdown voltages of the microwires with 25 μm in outer diameter and 3.
结果表明:玻璃包覆纯铜微丝在中性盐雾实验条件下,抗潮热盐雾腐蚀时间在240 h以上;对于外径25μm、包覆层厚度3。
2.
The salt spray test of ZM5 and ZM6 which were made of different purity magnesium ingot indicated that the corrosion rate in salt spray test of ZM5 and ZM6 which were made of high purity magnesium ingot is far lower than that of low purity magnesium; the influence of magnesium ingot purity to ZM5 is more notable than that to ZM6.
对不同纯度镁锭生产的ZM5和ZM6铸造镁合金的耐盐雾腐蚀的研究结果表明,高纯镁锭能明显降低ZM5,ZM6铸造镁合金的腐蚀速率,提高合金的耐盐雾腐蚀性能。
3.
The influence of pre-corrosion on the fatigue life of ultra-high strength steel AF1410 was studied using the salt spray test and fatigue test combination method.
采用盐雾腐蚀试验与疲劳试验相结合的方法,研究了预腐蚀对AF1410超高强度钢疲劳寿命的影响,并用扫描电子显微镜分析了疲劳断口形貌特征。
3) salt fog corrosion
盐雾腐蚀
1.
We also introduced the theory of salt fog corrosion and the method of salt fog.
同时本文对盐雾腐蚀机理和盐雾腐蚀防护措施做了介绍。
5) Salt Spray Corrosion Behavior
盐雾腐蚀行为
1.
Salt Spray Corrosion Behavior of As-cast and Spray Formed ZA35-3.5Mn Alloy;
铸态和喷射成形ZA35-3.5Mn合金盐雾腐蚀行为
6) acidic salt spray corrosion
酸性盐雾腐蚀
1.
The influence of acidic salt spray corrosion on the microstructure and high-temperature cyclic oxidation behavior of TBCs had been investigated.
采用酸性盐雾腐蚀试验对物理气相沉积法制备的热障涂层进行了常温腐蚀,研究了常温酸性盐雾腐蚀对热障涂层的微观形貌以及高温性能的影响。
补充资料：石油产品盐雾腐蚀试验
分子式：
CAS号：
性质：评价防锈油脂在盐水（人工海水）喷雾状况下对金属的保护性能的一种试验方法。试验在专门设计的盐雾箱中进行，所以有时也称石油产品盐雾箱腐蚀试验（salt-spray corrosion test for petroleum products）。将涂好试验油膜的试片，放入能连续喷出0.5～1.5ml/h盐水的盐雾箱中（盐水浓度为5%～6%），在（35±2）℃的条件下，按油品规格要求的时间进行试验，再按标准方法评定试片锈蚀级别。级别分别为0、1、2、3四个。
CAS号：
性质：评价防锈油脂在盐水（人工海水）喷雾状况下对金属的保护性能的一种试验方法。试验在专门设计的盐雾箱中进行，所以有时也称石油产品盐雾箱腐蚀试验（salt-spray corrosion test for petroleum products）。将涂好试验油膜的试片，放入能连续喷出0.5～1.5ml/h盐水的盐雾箱中（盐水浓度为5%～6%），在（35±2）℃的条件下，按油品规格要求的时间进行试验，再按标准方法评定试片锈蚀级别。级别分别为0、1、2、3四个。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条