1) Fe-B-C casting alloy
Fe-B-C铸造合金
1.
Under the condition of water cooling quenching,the influence of quenching temperature on microscopic structure and macroscopic hardness of Fe-B-C casting alloy which contents 0.
0%B的Fe-B-C铸造合金显微组织和宏观硬度的影响。
2) cast Fe-B-C alloy
铸造Fe-B-C合金
1.
The solidification structures of cast Fe-B-C alloy containing more than 2.
铸造Fe-B-C合金的凝固组织由Fe2B、铁素体和珠光体组成,硼化物呈网状沿晶界分布。
3) Cast Fe-B-Ti alloy
铸造Fe-B-Ti合金
4) Fe-B-C alloy
Fe-B-C合金
1.
The microstructure and properties of Fe-B-C alloy with different quenching temperature and mediator were studied through different heat treatment.
采用不同热处理工艺研究了淬火温度和介质对Fe-B-C合金组织和性能的影响。
2.
The as-cast and heat treatment structures and mechanical properties of wear resistant Fe-B-C alloy whose B and C ratio is 5 and carbon mass concentration is lower than 0.
4%(质量分数)的Fe-B-C合金的铸态和热处理组织以及机械性能。
3.
Effect of quenching temperature and cooling rate on the structure and properties of cast Fe-B-C alloy containing more than 1.
Fe-B-C合金在950~1000℃水冷淬火后,可以获得细小板条马氏体基体上分布高硬度硼化物的复合组织,硬度大于55HRC,冲击韧性大于15 J/cm2,综合力学性能优良。
5) Fe-C-B alloy
Fe-C-B合金
1.
Effect of heat treatment on microstructure and properties of wear resistant cast Fe-C-B alloy;
热处理对耐磨铸造Fe-C-B合金组织及性能的影响
2.
Investigation has been carried out on the microstructure and properties of Fe-C-B alloy.
对铸造Fe-C-B合金组织和性能进行了初步研究。
6) Fe-C-Cr-Mn Cast alloys
Fe-C-Cr-Mn铸造合金
补充资料：铸造合金
分子式：
CAS号：
性质：合金化程度较高，不易变形而采用精密铸造成型的合金，属于高温合金中高温强度最高的一种。按基本元素分类有镍基的、钴基的和铁基的。铸造高温合金主要用作燃气涡轮机的涡轮叶片。
CAS号：
性质：合金化程度较高，不易变形而采用精密铸造成型的合金，属于高温合金中高温强度最高的一种。按基本元素分类有镍基的、钴基的和铁基的。铸造高温合金主要用作燃气涡轮机的涡轮叶片。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条