1) Ni-NbC alloy
Ni-NbC合金
2) NBC alloy
NBC合金
1.
The influences of Y-based heavy RE and aging process on microstructure and properties of NBC alloy were studied.
结果表明,NBC合金经过分级时效处理后,耐磨性、耐腐蚀性和电导率有所提高,而显微硬度无明显变化;NBC合金经过稀土微合金化处理后,晶粒细化,显微硬度、耐磨性、耐腐蚀性和电导率均有不同程度的提高;NBC合金在添加了微量稀土的基础上并经分级时效处理后,材料性能进一步提高,特别是耐磨性能显著提高。
3) Ni-P alloy
Ni-P合金
1.
Research progress of electroless Ni-P alloys plating on aluminum alloy;
铝合金化学镀Ni-P合金的研究进展
2.
Study of magnetic Ni-P alloy on hollow glass microspheres by electroless plating technique;
空心玻璃微珠表面化学镀Ni-P合金磁性涂层的研究
3.
The electrochemical corrosion behavior of function gradient Ni-P alloy deposit in acidic and alkaline media;
功能梯度Ni-P合金镀层在酸性和碱性介质中的电化学腐蚀行为
4) Ni-Ti alloy
Ni-Ti合金
1.
Study on the vacuum hot-pressed technology of Ni-Ti alloys based on Ni and Ti foils;
基于箔带材Ni-Ti合金的真空热压工艺研究
2.
Preparation of Ni-Ti alloy by direct electrochemical deoxidation in low temperature molten salt
低温熔盐电解制备Ni-Ti合金
3.
The results show that Ti(C,N)-based cermets without Ni-Ti alloy present typical core-rim microstructure and nearly spherical shape of hard phase; the microstructure of cermets gets finer,and the shape of hard phase becomes multiangular with the increasing of Ni-Ti alloy,the interface between hard phase.
采用粉末冶金方法真空烧结制备了添加Ni-Ti形状记忆合金的Ti(C,N)-Co系金属陶瓷,研究了Ni-Ti合金对Ti(C,N)基金属陶瓷显微组织和力学性能的影响。
5) Ti-Ni alloy
Ti-Ni合金
1.
Preparation of diamond-like carbon films on Ti-Ni alloy by pulsed vacuum arc technique;
Ti-Ni合金上镀制类金刚石薄膜研究
2.
At the same time, the DSC curve gives the Ti-Ni alloy’s martensitic start temperature (Ms) and end temperature (Mf), the austenitic start temperature (As) and end temperatur.
同时,给出了Ti-Ni合金的马氏体起始温度Ms,马氏体结束温度Mf,奥氏体起始温As和奥氏体结束温度Af,并对其相变过程进行了判断。
3.
DSC curves in Ti-Ni alloys can be classified into 6 kinds.
结果表明,Ti-Ni合金的DSC曲线分6种类型。
6) Ni-Co alloy
Ni-Co合金
1.
A Study on Electrodeposition of Ni-Co Alloy and Structure of Deposit;
电沉积Ni－Co合金及其结构研究
2.
Microstructures and mechanical properties of pulsed electrodeposition nanocrystalline Ni-Co alloy;
脉冲电沉积纳米晶Ni-Co合金的组织结构与力学性能
3.
By the method of high frequency pulse electroplating, Ni-Co alloy coating was prepared.
采用高频脉冲电流,制备Ni-Co合金镀层。
补充资料：Antioxidant NBC
分子式：
分子量：
CAS号：
性质：学名N,N-二丁基二硫代氨基甲酸镍。黄绿色或深绿色粉末。密度约1.26，溶点86-88℃。溶于氯仿、苯、二硫化碳，不溶于水。对光、氧、臭氧和热有良好的稳定作用，可用作聚丙烯的光稳定剂，并广泛用作合成橡胶的抗臭氧剂和光稳定剂。由二丁基二硫代氨基甲酸钠与氯化镍反应而得。
分子量：
CAS号：
性质：学名N,N-二丁基二硫代氨基甲酸镍。黄绿色或深绿色粉末。密度约1.26，溶点86-88℃。溶于氯仿、苯、二硫化碳，不溶于水。对光、氧、臭氧和热有良好的稳定作用，可用作聚丙烯的光稳定剂，并广泛用作合成橡胶的抗臭氧剂和光稳定剂。由二丁基二硫代氨基甲酸钠与氯化镍反应而得。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条