1) quenching
液淬
1.
3Mn alloy on the morphology of dendrite α phase during solidification process was investigated by liquid quenching.
采用快速液淬方法,研究了Ca、Ce元素对Mg-6Al-0。
2) double-solution quenching
双液淬火
1.
While 9SiCr steel is used to replace Cr12 steel and a new process of double-solution quenching for edge and the whole isothermal quenching is adopted,the .
改用9SiCr钢并采用刃口双液淬火、整体等温淬火热处理,使碳化物均匀圆整,提高了刃口硬度、耐磨性和凸模整体的强韧性,使用寿命显著提高。
3) liquid quenching
液淬快冷
1.
Under conditions of liquid quenching , liquid phase precipitated α-phase firstly.
在液淬快冷的条件下,液相先析出α相,部分依附于初生固相晶粒结晶生长,部分在液相中独立形核生长。
4) Quenched structure
液淬组织
5) spray quenching
喷液淬火
1.
Considering the larger dimensions of the roller,its working condition and the requirements of service performance,a new procedure as using 45 steel with carburizing,boronizing and spray quenching has been put forward.
根据其尺寸较大的特点 ,结合其工作中的受力状态 ,使用性能要求等改用 45钢并经渗碳、渗硼、喷液淬火的复合热处理 ,提高了工作面的接触疲劳强度 ,消除了浅层剥落现象 ,提高了使用寿
6) quenching condition
液淬条件
参考词条
补充资料：双室油淬加压气淬真空炉ZYC_2-65
双室油淬加压气淬真空炉ZYC_2-65
双室油淬加压气淬真空炉zY02—65
说明：补充资料仅用于学习参考，请勿用于其它任何用途。