1) aluminum foil separator
铝箔分卷机
1.
This paper analyzes the problems inducing quality defects in course of operating the aluminum foil separator,discusses the relevant methods for improvement.
针对国产铝箔分卷机在使用过程中存在的问题,分析导致产品质量出现缺陷的原因,就有关改进方法进行探讨。
2) foil separater
铝箔分切机
1.
Three main problems about electrical control system of foil separater and slitter were analysed.
分析了铝箔分切机和铝箔剪切机电控系统设计中的三个主要问题：机列张力形成方式的选择，卷取张力控制方法的选择，卷径的测算。
4) aluminium foil mill
铝箔轧机
1.
The fatigue failure of working roller in aluminium foil mill was ana1ysed.
对使用中的铝箔轧机工作辊产生疲劳破裂的因素进行了分析。
2.
The life of double-column angular contact thrust ball bearing is very lower and it was easily damaged owing to superheat on operation side of the work-roll in 2350 high speed aluminium foil mill, which was generated by oversize axial force and castastrophic non-axial load.
某公司２３５０高速铝箔轧机操作侧止推双列角接触球轴承寿命低、易烧熔，其原因是过大的轴向力及严重偏载。
6) foil rolling mill
铝箔轧机
1.
In practical production,it is easy to take place the fire and equipment accidents due to super temperature of work roll bearings box in aluminum cold rolling mill and foil rolling mill.
实际生产中铝带材冷轧机和铝箔轧机易于发生由于工作辊轴承箱温度过高而造成的火灾和设备事故。
补充资料：渤海铝业有限公司铝箔分卷机分卷铝箔
渤海铝业有限公司铝箔分卷机分卷铝箔
渤海铝业有限公司铝箔分卷机分卷铝箔
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条