1) Parallel analyzer
平行检偏
2) the parallel deviation
平行偏差
1.
It was introduced that the process of the D505 laser axes adjusting meter in installing drive equipment,using the point-test of 9-12-3 to measure the parallel deviation and the angle deviation of the axes of the electriclocomotive and the gear case, at the same time, to measure the adjustment value and level up the value of the frontfeet and the back, to do a real time adjustment.
本文简要介绍了D505激光轴对中仪在纸机传动设备安装过程中,利用9-12-3点法测量出电机轴和齿轮箱轴平行偏差和角度偏差,同时给出前脚和后脚的调整值和垫平值,并实时调整,用实例说明了D505的精确性和适用性。
3) Parallel deviate
偏离平行
4) line frequency deviation
行平偏移
5) position deviation
平行偏差(平偏)
6) Parallel examination
平行检验
1.
This article carries on the brief elaboration analysis on the correspondence construction projects overseeing process in quality control as well as the quality control main method ( Side stands、 Patrolling、 Parallel examination ) and proposes own view and some suggestions.
文中就通信建设工程监理过程中的质量控制以及质量控制的主要方法(旁站、巡视、平行检验)进行简要论述分析,并提出自己的看法和一点建议。
补充资料：行检
1.操行，品行。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条