1) copper plate shape
铜板形状
1.
The causes of breakout during the production of low carbon steel for cold rolling by Tanggang FTSC thin slab caster were analysed and the optimization countermeasures such as the control of mould taper,the copper plate shape of mould narrow side and SEN shape were put forward.
分析了唐钢FTSC薄板坯连铸机生产低碳冷轧用钢过程中漏钢的成因;提出了优化锥度控制、改进结晶器窄面铜板形状和优化水口形状等技术措施。
2.
By researching the influence of copper plate shape,copper plate coming,,cooling structure of funnel mould on the solidify of thin slab and the heat transfer of mould,we analyzed the productive adaptability of H~2 funnel mould of Danieli,and optimized the shape of mould copper plate.
通过研究漏斗型结晶器的铜板形状、镀层、冷却结构对薄板坯凝固过程和结晶器传热的影响,分析了达涅利 H~2漏斗型结晶器生产应用的适应性,并据此对结晶器宽面、窄面铜板形状进行了优化。
2) copper plate distortion
铜板变形
1.
The effects of copper plate thickness, water slot depth and nickel layer thickness on copper plate distortion and stress were investigated.
建立了板坯连铸结晶器三维有限元热-弹塑性力学模型,模拟了生产过程中铜板结晶器的变形和热应力分布,考察了铜板厚度、水槽深度、镍层对板坯连铸结晶器铜板变形和热应力的影响规律。
3) blank shape
板坯形状
1.
The law of material's plastic flow and the stress-strain state is analyzed,and the effect on the formability of rectangular case by blank shape is analyzed with emphasis.
阐述了薄板拉深成形有限元模拟的基本理论及关键技术,对非轴对称拉深成形的典型零件—矩形盒进行了成形模拟,分析了材料流动规律和应力应变状态,并着重分析了板坯形状对矩形盒成形性的影响。
4) shape of chain gear tooth plank
齿板形状
1.
The curvilinear shape of chain gear tooth plank is the basic cause of saw-tooth phenomenon in the sintering pallet.
采取改造传统齿板形状等措施对3#烧结机进行了改造,改造后台车车轮离开道轨由60mm降到了10mm以内,实际运行电流由24A降为18A,台车使用寿命延长了6个月,年效益达63万元。
5) shape template metric
形状模板
补充资料：洛阳铜加工厂冷轧铜板带
洛阳铜加工厂冷轧铜板带
洛阳铜加工厂冷轧铜板带
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条