1) centrifugal infiltrating casting
离心渗铸
2) centrifugal casting
离心铸造
1.
Wear-resistance of Metallic Mold Centrifugal Casting TiAl Based Alloy;
金属型离心铸造TiAl基合金耐磨性研究
3) centrifugal cast
离心铸造
1.
In this paper,low-hardness high chromium roll was produced by means of designing reasonable centrifugal casting process and heat treatment method.
概括介绍了太钢轧辊公司利用5t中频炉、卧式工频炉、卧式离心机、低温电加热处理炉等设备,通过制订合理的离心铸造工艺和热处理工艺生产低硬度高铬铸铁轧辊,同时与热连轧磨辊间制订合理的磨削制度,满足了太钢热连轧的轧钢使用要求。
2.
The SiCp/Al alloy matrix composite was obtained through a new type of methodelectromagnetic centrifugal cast.
采用一种新型的工艺制备ＳｉＣ_Ｐ／Ａｌ合金基复合材料，即在传统离心铸造工艺条件下引入稳恒直流磁场，利用工艺中的电磁搅拌作用使离心铸造复合材料的偏聚情况得以改善，并探讨了稳直流磁场对颗粒分布均匀性的作用机理。
3.
Based on rapid prototyping technology the silicon rubber mold for centrifugal casting is conveniently made.
采用快速原型技术 ,可以方便地制造硅橡胶离心铸造模 ,适用于生产外形复杂的低熔点合金微小铸件。
4) Centrifugal casting
离心浇铸
1.
Determination of chromium, silicon, phosphorus in ferrochrome by X-ray fluoresence spectrometry using sample preparation technique of centrifugal casting;
离心浇铸制样X射线荧光光谱测定铬铁中铬、硅、磷
2.
Study on preparing the spectral type standard sample by centrifugal casting;
离心浇铸法制备光谱控制样的分析研究
3.
Determination of manganese,silicon,phosphorus in ferromanganese by X-ray fluorescence spectrometry with centrifugal casting preparation of sample;
离心浇铸制样-X-射线荧光光谱法测定锰铁中锰硅磷
5) centrifugally cast pipe
离心铸管
1.
The different processes used to make faucet cores for centrifugally cast pipes production as well as their advantages and shortages was described in detail,and compared from different angles.
详细叙述了生产离心铸管承口芯的不同工艺方法及其优缺点,并从不同角度加以对比。
6) centrifugal casting pipe
离心铸管
1.
Development of adiabaticrefractory coating on centrifugal casting pipe;
离心铸管用绝热-耐火涂料的研制
补充资料：渗渗
1.寒冷貌。 2.指因害怕而产生发冷的感觉。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条