1) dissolved silicon
溶解态硅
1.
A method based on Mg(OH)2 coprecipitation followed by cation-exchange separation for the determination of dissolved silicon in natural waters by ICP-MS was developed.
以Mg(OH)2共沉淀和阳离子交换树脂作为离线预富集方法,建立了天然水体中溶解态硅电感耦合等离子体质谱(ICP-MS)测定方法。
2) dissolve
溶解
1.
Research on temperature which wool keratin was dissolved by mercaptoethanol;
温度对巯基乙醇溶解羊毛角蛋白的影响
2.
Studies of solid phase diffusion-dissolve of Mg powder and Ni powder;
Mg粉和Ni粉固相扩散—溶解的研究
3.
Result shows that the organic releasing film basing on propanone dissolved acrylic resin can give aluminum film or aluminum flake with uniform thickness.
结果发现,通过丙酮溶解丙烯酸树脂基有机释放膜,可获得厚度十分均匀的铝膜或铝鳞片。
3) solubility
溶解
1.
Effect of alkali on ettringite crystallization and solubility;
碱对钙矾石结晶及溶解性能的影响
2.
Study on the Solubility of Three Kinds of Dental Cements at Early Stage;
3种水门汀早期溶解性比较研究
3.
The effects of temperature, pH, ionic strength and ionic variety on the nitrogen solubility(NSI) of chickpea protein isolate were investigated, and those of pH and ionic strength on emulsifying capacity(EC) and emulsion stability(ES) were also studied.
研究各种外部条件如温度、pH、离子强度、离子种类对鹰嘴豆分离蛋白质溶解性的影响以及pH、离子强度对乳化能力及乳化稳定性的影响。
4) solution
溶解
1.
Effect of CuAl_2 dissolution during solution treatment on the strength of AlCu-Si alloys after aging;
Al-Cu-Si合金中的CuAl_2相在固溶处理时的溶解对时效后强度的影响
2.
Numerical simulation of hydraulic fracture and solution of rock salt;
岩盐水压致裂溶解的数值模拟
3.
Mass transfer theories and models for pervaporation Ⅱ.Models for membrane sorption and solution;
渗透蒸发传质理论与模型 (Ⅱ )溶解行为
5) dissolution
溶解
1.
Effect of Matrices on Dissolution of Tungsten Carbide Particulates (WC) in WC Reinforced Iron Base Composite;
基体对WC颗粒在铁基复合材料中溶解的影响
2.
Structural characteristics of cellulose after dissolution and regeneration from the ionic liquid [bmim]Cl;
离子液体中纤维素的溶解及再生特性
3.
The changes of structure and dissolution in DMAc/LiCl of cellulose after pretreated with different methods;
不同预处理条件下纤维素的结构变化及其在DMAc/LiCl中的溶解
6) Dissolving
溶解
1.
Investigation of swelling-dissolving property of KGM-borate composite gel;
魔芋葡甘聚糖凝胶溶胀—溶解特性研究
2.
Study on the Dissolving Process of High Melting Point Component in TiAl Melt during ISM Process;
ISM过程中高熔点组元在TiAl熔体中溶解过程研究
3.
Cellulose Dissolving technology is a very key point in cellulose fiber producing,the result of cellulose dissolving will effect the quality of spinning solution,solution filtration,fiber forming and final product.
溶解技术是纤维素纤维制造过程中关键的技术,溶解的效果直接影响过滤、纺丝成形和最终产品的质量。
参考词条
补充资料：溶解态
分子式：
CAS号：
性质：水体中的悬浮物、沉积物及土壤中的金属于水中溶出而存在的化学形态(或化学状态)。溶解态金属在淡水中最主要的形态是简单的无机金属离子、水合金属离子、羟基络合物、碳酸盐络合物及与有机质结合的络合物。海水中除这些形态外，更多的是含氯络合物。这些不同的形态多数被无机或有机物质的胶体颗粒所吸附。分离测定溶解金属的方法：一般将水样通过孔隙度为0.45μm的滤膜，滤过的为溶解态，留在滤膜上的为颗粒态金属。
CAS号：
性质：水体中的悬浮物、沉积物及土壤中的金属于水中溶出而存在的化学形态(或化学状态)。溶解态金属在淡水中最主要的形态是简单的无机金属离子、水合金属离子、羟基络合物、碳酸盐络合物及与有机质结合的络合物。海水中除这些形态外，更多的是含氯络合物。这些不同的形态多数被无机或有机物质的胶体颗粒所吸附。分离测定溶解金属的方法：一般将水样通过孔隙度为0.45μm的滤膜，滤过的为溶解态，留在滤膜上的为颗粒态金属。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。