1) strand structure
绳股结构
2) stock right structure
股权结构
1.
Positive analysis of stock right structure and company performance;
股权结构与公司绩效的实证分析
2.
Research on the Optimization of the Stock Right Structure in Our Country s Listed Corporations;
我国上市公司股权结构优化问题研究
3.
The paper deals with unreason factors such as the stock right structure, property right system, legal person, corporation management and enterprise culture in the process of reforming corporation system which exist in most state-owned coal enterprises, and puts forward a set of efficient method.
针对我国大多数国有煤炭企业进行公司化改造中出现的股权结构不合理,产权制度滞后,法人治理不规范,公司治理、文化尚未配套等问题进行了探讨,进而提出了调整和完善公司治理结构的做法。
3) ply yarn structure
股线结构
1.
Mechanical analysis of the geometric disposition of single yarns in a ply yarn,the ply yarn structure,and the effect of twisting on increasing the strength of the ply yarn was carried out under the conditions that the ply yarn was bearing tensional load.
对受拉伸负荷时股线中单纱几何配置、股线结构和加捻对股线强力的增强效应进行了力学分析,指出了形成实心股线的条件,加捻对空心股线强力的增强效应大于实心股线,股线生产中一次合股加捻的单纱数不应超过5根,对股线强力要求高时,可采用多次并捻工艺。
4) Strand Construction
股结构
5) shareholding structure
股权结构
1.
An empirical analysis on the correlation between shareholding structure and firm performance in Chinese listed company;
我国股权结构与上市公司绩效的实证分析
2.
Empirical Study on Inpact between Shareholding Structure and Dividend Policy of Listed Company in China;
我国上市公司股权结构影响股利政策的实证研究
3.
The Research on the Relationship between Shareholding Structure and Operating Performance in China;
我国上市公司股权结构与经营绩效的关系研究
6) equity structure
股权结构
1.
Practical study on equity structure and company performance for listed companies in home appliance industry;
家电业上市公司股权结构与公司绩效实证研究
2.
The study of the equity structures and the optimizations of the listed companies in our country;
我国上市公司的股权结构及其优化研究
3.
Studying on Influencing Factors of Equity Splitting Reform Scheme——Based on equity structure and scheme characteristic;
股权分置改革方案的影响因素研究——基于股权结构与方案特征的分析
补充资料：绳股
绳股
strand
shenggu绳股(s trand)以若干根具有一定断面形状和直径的钢丝捻制成的螺旋状钢丝束。绳股用于充当捻制钢丝绳的基本元件，也叫股绳或股。绳股按断面形状分有圆股和异形股。异形股有三角股、椭圆股和扁股等(图1)。绳股的结构不同，组成绳股的各层钢丝间的接触状态也不同，而呈点接触(见.点接触钠丝绳)、线接触(见线接触钢丝绳)和面接触(见面接触钢丝绳)3种状态。务静释条 ab‘了肇留、撇 尹j人 图1绳股的形状和构成 a一1层钢丝画股;占2层钢丝圆股; ‘一异形钢丝绳股;d一股芯为纤维芯的绳股; e一股芯为纤维芯的2层钢丝绳股;了一三角股; g一扁股;h一椭圆股 绳股应使用符合标准规定的各种光面或镀锌圆钢丝或异形钢丝(梯形、轨形、Z形和三角形等)捻制。孔扮 图2绳股生产工艺流程捻股前将钢丝由打轴机缠绕在工字轮上(见打轴)，然后将缠有钢丝的工字轮装在捻股机上捻制成绳股，其生产工艺流程如图2。带有纤维股芯的绳股，在捻制时，钢丝在捻股机上围绕股芯(见绳芯)捻制而成。绳股的质量与所选择捻股机的型号(即工字轮大小)有关，如若捻制较粗的钢丝，而选用较小的工字轮时，则捻股时不仅换轴频繁，增加捻股辅助时间影响作业率，而且使绳股内钢丝接头增多，从而降低绳股质量。对不同直径的工字轮规定了适用钢丝的规格。 (阮煦裹)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条