1) liquid-liquid mass transfer
液液传质
1.
Aiming at the interfacial phenomena of liquid-liquid mass transfer and its characteristic,by using of the real-time holographic technique,the concentration distributions on the aqueous side were obtained according to holographic diagrams of mass transfer of ethanol through the interface of oil and water at different initial concentrations.
为了研究液液传质过程的界面现象及传质特征,采用实时激光全息干涉技术,根据不同初始浓度时乙醇通过油水界面传质过程的全息干涉图,得到了传质过程水相侧的浓度分布,据此求出了近界面浓度和基于浓度的传质系数,并关联了近界面浓度与主体相溶质浓度的关系。
2) film mass transfer
液膜传质
1.
The diffusivity of EM was determined by fitting the adsorption rate curves for different temperatures and initial EM concentrations, and the film mass transfer coefficient and pore diffusion coefficient we.
采用液膜及孔内扩散模型,模拟不同温度和不同红霉素(EM)初始浓度条件下,大孔吸附树脂HZ816及XAD16吸附红霉素的动态吸附曲线,并获得液膜传质及孔内扩散系数;考察了温度及溶质浓度对红霉素在两种树脂中吸附动力学的影响。
2.
With the film mass transfer,porous diffusion and axial dispersion were taken into account,and a film and pore diffusion model was employed to describe the diffusive mass transfer of .
并采用基于液膜及孔内扩散模型的动力学模型,同时考虑吸附树脂颗粒内外扩散阻力及轴向扩散的影响,研究了固定床上红霉素在大孔吸附树脂中的吸附动力学,并从穿透曲线回归得到液膜传质系数孔内扩散系数。
3) gas-liquid mass transfer
气-液传质
1.
The experimental results show that compared with air-deionized water system the addition of the surface-active additives into water will intensify gas-liquid mass transfer process significantly,which only occurs in a narrow concentration range.
实验结果表明,与空气-去离子水体系相比较,添加微量表面活性物质会显著增强氧的气-液传质性能,但这种强化作用仅发生在一定的浓度范围内,超过极限浓度后,液相体积传质系数会有所降低。
4) liquid-solid mass transfer
液固传质
1.
Measurements of liquid-solid mass transfer coefficient and liquid flow-rate within catalyst capsule;
液固传质系数和催化剂包内液体流速的测定
2.
The gas-liquid mass transfer characteristic and the liquid-solid mass transfer characteristics of air-water-ion exchanger resin system were studied in a 1L ultrasonic internal airlift loop reactor.
研究了超声内环流气升式反应器中空气-水-离子交换树脂体系的气液传质与液固传质性能。
3.
The liquid-solid mass transfer coefficients are sensitive to the liquid flow rate,but independent on the gas flow rate.
采用苯甲酸颗粒-水-空气系统,进行了气液两相逆流状态下的传质实验,获得了规整装填和散堆装填两种不同装填方式对液固传质系数的影响。
5) gas liquid mass transfer
气液传质
1.
The gas phase mass transfer process was studied experimentally based on the double film theory when chlorine and acetone chlorinated in a short parallel flow wetted wall tube,and the effect of acetone liquid flow rate( V L) and chlorine gas flow rate ( Q G) and the length ( l ) of the wetted well tube on the gas liquid mass transfer rate has been investigated.
统计回归分析得到气液传质通量NG=0 。
2.
The new high effective gas liquid mass transfer stirred reactor: Self mixing Disk Turbine(SDT) was designed.
提出了一类新型高效气液传质设备 :自混式圆盘涡轮搅拌设备 (SDT) ,以提高气液反应设备的传质效果 ,降低剪切力。
3.
Interfacial properties have an important act on gas liquid mass transfer.
界面性质对气液传质有重要影响。
6) gas-liquid mass transfer
气液传质
1.
Studies on gas-liquid mass transfer characteristics of horizontal vessel;
卧式搅拌釜气液传质性能研究
2.
Study on characteristics of gas-liquid mass transfer in vinylidene fluoride emulsion polymerization reactor;
偏氟乙烯乳液聚合的气液传质效果影响因素的研究
补充资料：鞴液
1.谓熔化成液体。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条