1) magnesium plate and strip
镁合金板带
1.
It also summarizes the new progress in magnesium plate and strip rolling.
介绍了世界镁及其合金板带轧制的发展历史,镁合金板带的常规轧制工艺,典型镁合金板带的力学性能。
2.
The new progress in magnesium strip roll casting is dwelled on,other magnesium plate and strip producing technologies are summarized in this part.
介绍了世界镁及其合金板带轧制的发展历史,镁合金板带的常规轧制方法,典型镁合金板带的力学性能。
2) magnesium alloy sheet
镁合金板
1.
The influence of processing parameters on the friction factor of corners in warm forming die for magnesium alloy sheet;
工艺参数对镁合金板温成形模具圆角摩擦因数的影响
2.
Based on newly developed tribotest device,the friction coefficient in die corner during warm forming of magnesium alloy sheet was tested.
利用自行研制的新型摩擦测试装置,对镁合金板温成形过程模具圆角部位摩擦系数进行了测试实验。
3.
Analysis of texture inhomogeneity in cold rolled magnesium alloy sheet;
镁合金板材的织构不均匀性,有利于镁板的进一步冷轧。
3) Magnesium alloy sheets
镁合金板
1.
Deformation behaviors of AZ31B magnesium alloy sheets in hydromechanical deep drawing
AZ31B镁合金板液压-机械拉深试验研究
5) magnesium alloy sheet
镁合金板材
1.
Influence of intermediate annealing on microstructure and mechanical property of magnesium alloy sheet;
中间退火对镁合金板材组织和性能的影响
2.
The textures of AZ31B magnesium alloy sheets in the conditions of hot rolling, cold rolling and heat treatment were investigated, and its feature and influence to the mechanical property anisotropy were studied.
结果表明:轧制镁合金板材具有主要以基面织构为主的板织构,其基面平行于板面,其他织构组分相对较弱;冷轧后的基极密度中心围绕板横向向轧制方向旋转约18°;冷轧后在300℃热处理对织构分布特征影响不大。
6) magnesium alloy sheets
镁合金薄板
1.
Adaptive arc length control for magnesium alloy sheets TIG welding;
镁合金薄板TIG焊自适应弧长控制
补充资料：板带
1.宽而硬的腰带。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条