1) maximum pressure point
压力最大处
1.
This article makes a theoretical analysis of the air current at the back sheet of a card and propose the concept of gauge ratio,assuming that at the back sheet exists a maximum pressure point whose location is related with gauge ratio,pressure difference,exit gauge and back sheet length.
对梳棉机后罩板处的气流理论进行分析,提出隔距比的概念,认为后罩板处有一压力最大处,其位置与隔距比、压力差、出口隔距及后罩板长度有关;同时对梳棉机后罩板处的研究现状进行了归纳和总结,认为单独加装棉网清洁器对成纱质量是有利的,风量以180~240 m3/h为佳,单独加装固定盖板对成纱质量也是有利的,隔距应偏大掌握,且根数不宜过多,固定盖板与棉网清洁器配合使用,效果更佳,并提出其安装位置在后罩板压力最大处为宜。
2) maximum pressure
最大压力
1.
on the maximum pressure of current rush to air mass.
从理论上研究了阀门前充水段长度、滞留气团的初始长度、多方指数n等参数对输水管道水流冲击气团最大压力的影响。
3) maximum rolling pressure
最大辗压力
1.
Finite element analysis of maximum rolling pressure of rotary roll forming for straight tooth bevel gear;
直齿圆锥齿轮摆辗成形最大辗压力的有限元研究
4) maximu press stress
最大压应力
5) maximum pressure angle
最大压力角
1.
Taking the MATLAB as an auxiliary tool,the optimization designing method for basic dimensions of the disk cam mechanism with translation push rod while the push rod realizes the regular basic movement was presented,thus letting the volume of cam mechanism and the maximum pressure angle reached a minimum.
以MATLAB为辅助工具,给出了直动推杆盘形凸轮机构在推杆实现规律的基本运动时的基本尺寸优化设计方法,使凸轮机构的体积和最大压力角达到最小。
2.
A method for optimizing the main dimensions of a cam-oscillating follower mechanism in common follower motions is presented with the MATLAB,which maximizes the cam volume and maximum pressure angles.
以MATLAB为辅助工具,给出了摆动推杆盘形凸轮机构在基本推杆运动规律时的基本尺寸优化设计方法,使凸轮机构的体积和最大压力角达到最小。
6) max external pressure
最大外压力
1.
Analysis and research were made for relation about max external pressure resisting capacity under condition of different ratio between straight section length and end arc radius on the flatted tubes with same circumference and tube wall thickness by using analytical technology of finite element.
应用有限元分析方法,对相同周长、相同壁厚的扁管在直边段和圆弧半径的不同比值条件下与所能承受最大外压力的关系进行了分析。
补充资料：大处
1.大地方。 2.大的方面。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条