1) dry-type start-up
湿式启动
2) initial moisture load
启动湿负荷
1.
To prevent dew condensation on a cooling floor, introduces the concept of initial moisture load and a procedure for determining it based on the initial dew point, pull-down time etc.
针对地板辐射供冷的结露问题 ,引入了启动湿负荷的概念及利用房间初始露点、启动时间等参数计算启动湿负荷的方法 ,给出了除湿机组容量选用表 ,分析了控制方式对除湿机组容量的影响 ,讨论了置换通风用于地板表面除湿的可能性。
3) Starting method
启动方式
1.
Through changing the starting method of a test unit for a three-phase motor,the constraint relationship between the test unit and the production power load can be solved,thus the starting can be done at any time,and the energy can be saved.
通过改变三相电动机试验机组的启动方式,解决试验机组启动与生产电力负荷之间的制约关系,达到了随时启动的效果,同时节约了电能。
4) starting mode
启动方式
1.
The paper introduces AC Softing Start principle,the soft starting mode,combines the characteristics of belt conveyor,notes chooseing soft starting benefits in belt conveyor application.
通过与传统液压启动方式比较,指出了软启动在带式输送机上的应用是必然的发展方向。
2.
Taking the start mode of reclosing in CSL160B series digital series protective devices as the examples,this paper analyzes the differences between this kind of starting mode and conventional tarring mode of reclosing,and probes into the existing problems,and advances some solving methods.
以CSL160B系列数字式保护装置中重合闸启动方式为例,分析了此种启动方式和常规的重合闸启动方式的不同,探讨了存在的问题,并提出了解决办法。
3.
Wherefore,it is very important of the appropriate starting mode to decrease the transformer capacity and ensure the security of starting.
因此,选择合理的启动方式,对减小变压器容量及启动的安全性尤为重要。
5) start-up mode
启动方式
1.
A technical and economical comparison was carried out for selection of turbine start-up mode and arrangement of its bypass system of 1 000 MW extra supercritical units in Zouxian Power Plant.
为选择邹县电厂1 000 MW超超临界机组汽轮机的启动方式和旁路系统的配置方式,进行了技术分析和经济比较。
2.
7/537/537-4 turbine as an example,this paper makes the brief introduction to the start-up process of IP cylinder,analyzes and summarizes the start-up mode of IP cylinder by comparisom with that of other type units.
7/537/537-4型汽轮机的冷态中压缸启动为例,对其启动过程作了简要介绍,并在参照其他类型机组启动的基础上,对中压缸启动方式作了分析和总结。
3.
The over-voltage calculation and analysis of the basic operating conditions under the start-up mode and the conventional condition after putting into service were carried out, which can reach to change the start-up mod.
针对安徽电网500kV紧凑型长距离输电线路,由于配置并联电抗器及中性点电抗器,在某些运行方式下将产生谐振的现象,文章介绍了一种采用EMTP电磁暂态计算的软件,对启动方式及投运后常规情况下可能发生的基本运行工况进行了过电压计算和分析,达到更改启动方式,完成线路安全启动的作用。
6) start mode
启动方式
1.
,and points out the notices of IP start and HP start,and compares the merits and demerits of the two start modes.
结合托电600MW机组汽轮机的实际运行情况,介绍2台600MW日立公司生产汽轮机的结构特点,中压缸及高压缸启动注意事项,比较中压缸启动方式和高压缸启动方式的优缺点。
2.
Based on the relationship between protection mode and the transient stability, this paper proposes the control strategy of over-voltage protection, and studies the start mode of protective bypass.
在分析TCSC过电压保护方式与暂态稳定关系的基础上,提出过电压保护的控制策略,研究了保护性旁路的启动方式,并借助ARENE软件予以仿真验证。
补充资料：湿基湿含量
分子式：
CAS号：
性质：为了表示湿物料的含湿（水）量，常以单位质量湿物料为基准表示所含湿分（水分）的质量，称为湿基湿含量。参见湿含量条目。
CAS号：
性质：为了表示湿物料的含湿（水）量，常以单位质量湿物料为基准表示所含湿分（水分）的质量，称为湿基湿含量。参见湿含量条目。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条