1) buffer
[英]['bʌfə(r)] [美]['bʌfɚ]
缓冲器
1.
Application and design of the foam metalic buffer;
泡沫金属缓冲器的设计新方法及应用
2.
A Voltage Reference Buffer for 12-Bit 100MHz Pipelined A/D Converter;
12位100MS/s流水线A/D转换器的参考电压缓冲器
2) draft gear
缓冲器
1.
Die forging techniques for the center block of high capacity draft gear;
大容量缓冲器中心楔块模锻工艺
2.
Development of couplers and draft gears for locomotive & rolling stock at home and abroad;
国内外机车车辆用车钩缓冲器发展综述
3.
Secondary development of the software ANSYS and its application to die forgings for heavy-duty draft gears;
ANSYS软件的二次开发及其在大容量缓冲器模锻件上的应用
3) shock absorber
缓冲器
1.
An analysis and design calculation of shock absorber performance parameters for telescopic landing gear,including initial pressure and volume,orifice area,piston area and total strut stroke etc,are presented.
主要介绍支柱式起落架缓冲器的各个参数,包括缓冲支柱的初压力、初容积、油孔面积、活塞面积、缓冲支柱行程等。
2.
The performance parameters of the shock absorber are designed based on comprehensive locomotion and force analysis, and then are proofed by energy methed.
通过建立起落架的运动模型及数学模型,在进行了全面的运动分析和受力分析的基础上,经过计算初步确定了缓冲器的性能参数,然后用能量法对缓冲器的参数进行了核验计算。
3.
An integration method of shock absorber performance analysis, test and design of aircraft landing gears is presented.
利用起落架落震试验结果，自动识别缓冲器空气压缩多变指数和油孔流量系数等不可测参数，以便建立准确的起落架数学模型；并在此基础上对缓冲器充填参数和油孔尺寸进行优化设计，使得起落架着陆最大冲击载荷达到最小。
4) damper
[英]['dæmpə(r)] [美]['dæmpɚ]
缓冲器
1.
Basing on rheological dynamics,a damper with sealed clearance type of annular gap structure is applied to a landing gear and analyzed.
针对流变力学的特点,在起落架上采用了间隙密封式环形截流口结构的缓冲器,并对其进行了力学分析,根据实际情况,对缓冲器的受力进行了简化;基于Bingham模型建立了缓冲器的力学模型,并对其进行了仿真分析。
2.
Based on rheological dynamics,a damper with sealed clearance type of annular gap structure was applied to landing gear,and analyzed.
在起落架上采用了间隙密封式环形截流口结构的磁流变缓冲器,并对其进行了力学分析,根据实际情况,对缓冲器的受力进行了简化;基于Bingham模型建立了缓冲器的力学模型,并对其进行了仿真分析。
3.
Based on ADAMS mechanical simulation software, a gravity environment was established by computer and some simulation study had been carried out about the landing gear damper.
对直升机以一定速度坠落时产生的冲击振动等动力学响应进行了仿真研究,基于能量原理和振动理论,理论推导得出了该型直升机主起落架缓冲器纵向振动微分方程计算公式,并在动力学仿真软件ADAMS基础上,进行了数字仿真机算。
5) draft gears
缓冲器
1.
Described are the elevating type impact test stand for vehicles and draft gears.
介绍了一种可升降的车辆及缓冲器冲击试验台,通过调整其轨道角度,可实现对不同的车辆冲击速度的控制,并可完成对车钩缓冲器及车辆冲击应力的测试。
2.
On the basis of the classified evaluation of the existing draft gears, the ПМКП-110 new impact type draft gears and the ЭПА-120 elastomer type draft gears with big capacity for rolling stock are developed.
在对既有缓冲器结构进行分级评估的基础上,研制出了铁道车辆用ПМКП-110型新的冲击式缓冲器和ЭПА-120型大容量弹性胶泥缓冲器。
3.
The effect of the initial pressure on the performance of draft gears and its importance are expounded.
阐述了初压力对缓冲器性能的影响和其重要性,并对几种典型车钩缓冲器的初压力状况进行了分析。
6) buffer rcgister
缓冲缓存器
补充资料：缓冲器
见车钩缓冲装置。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条