1) mold filling temperature
充型温度
1.
The FEA software ANSYS was applied to the numerical simulation coupling temperature field with velocity field to analyze the effect of mold filling temperature on the flow and temperature distribution of semi-solid slurry of A356 alloy during thixo-forming.
利用ANSYS有限元模拟软件,通过对温度场与速度场的耦合数值模拟,分析了触变成形过程中充型温度对A356合金半固态浆料流动及温度分布的影响。
3) charge air temperature
充气温度
4) vapor-filled thermometer
充气温度计
5) Filling Velocity
充型速度
1.
The Influence of Various Process Parameters on the Liquid Metal Filling Velocity in Gray Iron Casting Produced by EPC V Process;
铸铁件EPC-V法工艺因素对充型速度的影响
2.
The result indicats that there are few blowholes,inclusions except misrun in the casting with the filling velocity of 25mm/s,and the casting was formed with some blowholes、inclusions with the filling velocity of 40mm/s,while the casting was form.
研究了薄壁铝合金铸件真空吸铸充型速度对其内部质量的影响,对一种200mm×180mm,壁厚为2。
3.
The metal filling velocity increases with the reduction of pattern density and coating thickness, and the increase of pouring temperature.
研究了模样密度、涂层厚度、浇注温度、真空度等工艺参数对可控气压下镁合金消失模铸造时液态金属的充填形态和充型速度的影响,以及充型速度与充型形态之间的关系。
6) filling speed
充型速度
1.
The filling speed of lost foam cast iron casting was measured by use of an integrated set of experimental equipment and a specially designed computer acquisition system.
研究了负压度、模样密度、浇注温度、金属静压头等工艺因素对消失模铸铁件充型速度的影响规律。
补充资料：充炭黑充油丁苯橡胶
分子式：
分子量：
CAS号：
性质：同时含有炭黑和油的丁苯橡胶。性能和用途与充炭黑丁苯橡胶和充油丁苯橡胶相似。由冷聚丁苯胶乳与炭黑的水分散液和油乳液经混合、凝聚、洗涤、过滤、干燥等步骤制得。
分子量：
CAS号：
性质：同时含有炭黑和油的丁苯橡胶。性能和用途与充炭黑丁苯橡胶和充油丁苯橡胶相似。由冷聚丁苯胶乳与炭黑的水分散液和油乳液经混合、凝聚、洗涤、过滤、干燥等步骤制得。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条