说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 浸渍型吸附剂
1)  impregnated adsorbent
浸渍型吸附剂
2)  soak [英][səʊk]  [美][sok]
吸收;浸渍
3)  impregnant [英][im'pregnənt]  [美][ɪm'prɛgnənt]
浸渍剂
1.
Discussion on Vegetable Oil as the Capacitor Impregnant;
植物油用作电容器浸渍剂的探讨
2.
The viscosity of tantalum impregnant,which was researched by ourselves,was analysised in a cer- tain temperature range(295~328K)by NDJ—7 rotary viscometer.
采用NDJ—7旋转式粘度计分析了自主研发的含钽浸渍剂在一定温度范围(295~328K)的粘度特性,发现该温度范围内含钽浸渍剂具有较低的粘度和很好的流变性能。
3.
Proceeding from introducing the characteristics and properties of phenol resin and Furan resin used as graphitematerial impregnant, this article analyzes the necessity and former achievement as well as existing problem of using Teflon as graphitematerial impregnant, promotes the possibility of solving above problems by experiments meantime achieves new process methodsuccessfully.
本文在介绍了酚醛树脂、呋喃树脂做石墨材料浸渍剂的性能及特点的基础上分析了聚四氟乙烯做石墨材料浸渍剂的必要性及以前所取得的成果及存在的问题,通过实验提出了解决这些问题的可能性,并成功实现了聚四氟乙烯浸渍石墨的新的工艺路线。
4)  impregnation solvents
浸渍溶剂
1.
Effect of impregnation solvents on the catalytic properties of Rh-Mn-Li/SiO2 catalyst was investigated by means of the following techniques: CO hydrogenation reaction,temperature-programmed desorption of absorbed CO(CO-TPD),temperature-programmed surface reaction(TPSR) and X-ray photoelectron spectroscopy(XPS).
采用CO加氢反应、CO-TPD、TPSR和XPS等技术,考察了水、甲醇、乙醇和异丙醇等浸渍溶剂对Rh-Mn-Li/S iO2催化剂CO加氢性能的影响。
5)  RFL solution
RFL浸渍剂
1.
The regression design method was used to optimize the recipe of RFL solution for polyester cord.
拟合了配方中甲醛与间苯二酚的摩尔比(MF/MR)、RF树脂与丁苯吡胶乳的质量比(mRF/mL)和RFL浸渍剂质量分数(A)与浸胶帘线使用性能之间的回归方程,并对回归方程进行显著性检验。
6)  impregnating [英][im'pregneit]  [美][ɪm'prɛg,net]
浸渍剂
1.
The verification and analysis of test methods for the determination of bond strength of the impregnating agents with the twisted coil;
扭绞线圈试验测定浸渍剂粘结强度验证与分析
2.
This paper studies the effect of the preparation processes and break ways on the bond strength of the impregnating agents with the twisted coil during the verification of IEC 61033 in order to establish our corresponding national standard.
论文叙述了在依据国际电工委员会标准IEC61033:1991制定国家标准GB/T 11028-1999《测定浸渍剂对漆包线基材粘结强度的试验方法》过程中,应用数理统计学中“t”分布检验验证扭绞线圈试验方法测定浸渍剂粘结强度时,固化工艺、破坏速度(时间)及在不同的温度下处理时间对浸渍剂粘结强度的影响。
补充资料:酸化吸附型缓蚀剂
分子式:
CAS号:

性质:通过吸附在金属表面上而起缓蚀作用的缓蚀剂。主要有烷基胺、咪唑啉、苯胺、乌洛托品等。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条