1) resilience
[英][rɪ'zɪliəns] [美][rɪ'zɪlɪəns]
恢复力
1.
An overview on the resilience of social-ecological systems;
社会-生态系统恢复力研究综述
2.
Evaluation of ecosystem resilience in the regions across Qinghai-Tibet railway based on GIS;
基于地理信息系统的青藏铁路穿越区生态系统恢复力评价
3.
The Adaptive Cycle Mechanim and Versue Arid Resilience of Rural Social-Ecological System in the Loess Plateau;
黄土高原典型农村社会—生态系统适应性循环机制及对干旱的恢复力
2) restoring force
恢复力
1.
The seismic isolation effectiveness,such as displacement,equivalent horizontal stiffness,max-restoring force,dissipation per loop and equivalent damping ratio of the SMA strands-composite bearing is analyzed and compared with laminate rubber bearing,through the results of the shaking table test on them.
根据试验结果比较分析了SMA绞线-叠层橡胶复合支座与普通叠层橡胶支座的隔震性能,着重分析了位移幅值对支座工作性能基本参数如等效水平刚度、最大恢复力、单位循环耗能和等效阻尼比的影响以及这些参数的变化规律。
2.
Properties of plastic hing are analyzed so that restoring force curves of steel reinforced concrete and reinforced concrete are computed and pattern of horizontal force according with the tall building is put forward.
分析了塑性铰的特性及相对位置的确定,计算了钢筋(型钢)混凝土构件的恢复力曲线;对比了理论计算和试验实测水平剪力分布模式,提出符合模型结构特点的水平力分布模式。
3.
The restoring force of the isolation system is studied, and the dynamic response program of the isolation system under earthquake excitation is drawn up in the time domain.
运用隔震理论建立结构隔震体系的动力模型和运动方程,着重考虑了隔震体系的恢复力特性,进行了隔震体系在时域内的地震反应程序设计。
3) restoring ability
恢复力
1.
In this paper,resistance of F_1 generation originated by rice gall midge(GM)-resistant rice varieties crossed with rice male sterile lines were evaluated and restoring ability of GM-resistant rice varieties were tested.
测交结果表明,抗蚊青粘和植选8号恢复力较好。
4) revegetation potentiality
恢复潜力
1.
Evaluation model for revegetation potentiality of sand dust sources in farming-pastoral ecotone in Northern China;
北方农牧交错带沙尘源植被恢复潜力评价模型研究
5) recovery stress
恢复应力
1.
The study results of the shape memory property of the film after annealing and crystallization show that the film has 180 MPa of maximum recovery stress and 2.
5 h晶化处理后无残余塑变存在下的最大恢复应力、最大恢复应变分别为180 MPa、2。
2.
The constraint transformation behavior of 7% strained TiNi alloy was investigated, and the experimental results show that the recovery stress formed at the first constraint transformation thermal cycling is the highest, and then decreases with increasing the constraint transformation thermal cycling number.
研究了预变形TiNi合金应变约束态下的相变行为,结果表明:7％应变TiNi合金变形后第1次应变约束相变产生的恢复应力最大,逆相变开始温度A_s′(2)最高,随着约束相变循环次数的增加,合金中引入大量塑性变形,降低了TiNi合金的恢复应变,进而造成TiNi合金约束相变恢复应力最大值逐渐降低,但约束逆相变开始温度A_s'第2次相变循环开始,几乎恢复到合金变形前的原始值,且不随相变循环次数增加而改变。
6) pressure build-up
压力恢复
1.
In this article,through analyzing pressure build-up speed of the reservoir,the writer determines the appropriate well killing fluid densities which are suitable for different pressure build-up speed and operating cycle.
由于高压低渗裂缝性储层导压能力较弱,关井后压力恢复缓慢,因此根据地层压力确定的压井液密度偏高、易造成储层污染,通过对储层压力恢复速度进行分析,确定出适用于不同压力恢复速度和施工周期的压井液密度,现场应用后取得了较好的油层保护效果和经济效益,并为同类储层压井液密度的选择提供了良好的借鉴。
2.
The types of gas reservoir and pressure build-up test curve are complex,characterized by different interpretation models,leading to the difficulty in well test analyses.
川西致密砂岩气藏属于典型的致密低渗复式气藏 ,气藏类型及其压力恢复曲线形态复杂 ,其解释模型也各不相同 ,这给试井解释工作带来了极大的困难。
3.
Aiming at phenomenon of abnormal gas well shut down pressure build-up curve (i.
针对气井关井压力恢复曲线异常(即关井后井底压力上升时井口压力下降)的现象,基于现场测试数据和文献调研,修正了井底压力计算模型。
补充资料：赤力力
1.亦作"赤历历"。 2.象声词。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条