1) dispersion
[英][dɪ'spɜ:ʃn] [美][dɪ'spɝʒən]
分散液
1.
Preparation of polyurethane/acrylic hybrid dispersions via miniemulsion polymerization process;
微小乳液聚合制备丙烯酸酯杂化聚氨酯分散液
2.
Preparation of calcium stearate dispersion with low viscosity
低黏度硬脂酸钙分散液的制备
3.
Concept of PTFE dispersion and its performance are introduced.
介绍了聚四氟乙烯分散液的概念和有关性能。
2) dispersions
分散液
1.
Research progress of aqueous polyurethane dispersions;
水性聚氨酯分散液的研究进展
2.
A series of aqueous polyurethane dispersions were synthesized with sulfonate group-containing polyester diol and IPDI as primary materials and DMPA as hydrophilic monomers.
以含有磺酸盐基团的聚酯二元醇和异佛二酮二异氰酸酯(IPDI)为主要原料,用二羟甲基丙酸(DMPA)为亲水单体制备了一组不同组成的聚氨酯分散液,经测定粒径和力学性能,研究了磺酸盐基团含量对分散液及其胶膜性能的影响。
3) liquid-liquid dispersion
液-液分散
1.
Effect of multiple impeller agitators on liquid-liquid dispersion in a multi-impeller stirred tank;
搅拌槽内多层组合桨对液-液分散特性的影响
4) liquid-liquid dispersions
液液分散
1.
Several liquid agitating criterions were introduced, and applicable scale-up criterions were put forward for flow-sensitive type agitating, gas-liquid dispersions, liquid-liquid dispersions, solid suspension and crystallization.
介绍了几种常用的液体搅拌放大的判据,并对流量型搅拌、气液分散、液液分散、固液悬浮以及结晶过程的搅拌,分别提出了适用的放大判据。
6) aqueous dispersion
水分散液
1.
Aimed at recently existing drawbacks of insufficient heat resistance and water-resistance of films formed from polyurethane aqueous dispersions(PUD),the research progresses of their modifications with siloxanes(PSi) are introduced.
针对聚氨酯水分散液(PUD)胶膜目前存在的耐热、耐水性能的不足,介绍了用聚硅氧烷(PSi)改性的研究进展。
2.
Stable bisphenol type epoxy resin hybrid aqueous dispersion was modified by solution polymerization with acrylate monomers.
利用傅立叶变换红外光谱仪测试了改性聚合物的结构,用ZETA电位分析仪测定了水分散液的粒径及其分布,用透射电子显微镜观察了乳液粒子形态。
3.
Stable epoxy-styrene-acrylic hybrid aqueous dispersion modified by siloxane was prepared.
采用化学方法制备了稳定的硅氧烷改性环氧-苯丙复合水分散液,红外光谱表征聚合物结构,动态激光光散射测量水分散液粒径及其分布,透射电镜观察粒子形态。
补充资料：聚全氟乙丙烯水分散液
分子式：
CAS号：
性质： 四氟乙烯-全氟丙烯共聚物水分散液在乳化剂的存在下，于一定的温度下浓缩分层，得到固含量50％左右的半透明乳白色的水分散液。该分散液宜在5～25℃下贮存，贮运时避免振荡、高温、曝晒和严寒，以防凝聚。分散液具有聚全氟乙丙烯树脂的各种优良性能，能在205℃下长期使用，利用其优异的不粘性和耐腐蚀性，可作为其他材料的防黏、防腐涂层。
CAS号：
性质： 四氟乙烯-全氟丙烯共聚物水分散液在乳化剂的存在下，于一定的温度下浓缩分层，得到固含量50％左右的半透明乳白色的水分散液。该分散液宜在5～25℃下贮存，贮运时避免振荡、高温、曝晒和严寒，以防凝聚。分散液具有聚全氟乙丙烯树脂的各种优良性能，能在205℃下长期使用，利用其优异的不粘性和耐腐蚀性，可作为其他材料的防黏、防腐涂层。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条