1) deforming ample degree
变形余裕度
1.
Research on choice evaluation of sheet cutting shape based on deforming ample degree;
基于变形余裕度的冲压板材成形选择评价研究
2) Sustaining margin
记忆余裕度
3) form clearance
齿形裕度
4) bottom allowances
底裕度(储器底之余裕)
5) residual strain
残余变形
1.
It is recognized that the latter is resultful in decreasing welding residual stress as well as welding residual strain.
采用热弹塑性有限元法 ,对直通焊和多人同时分段焊两种焊接过程的平板对接焊时焊接应力变形和圆柱壳板环缝的焊接变形进行比较 ,认为多人同时分段焊较直通焊无论在降低焊接残余应力还是焊接残余变形都具有非常显著的效
2.
A simple empirical model for predicting residual strain under repeated load suitable for soft clays is proposed based on test results.
基于以往试验规律的分析,提出了一个较为合理地描述软土在长期重复荷载作用下残余变形发展过程的经验模型。
6) residual deformation
残余变形
1.
Analysis and application of treatments to diminish residual deformation of saturated clay subgrade;
湿软路基残余变形控制技术及其工程应用
2.
Study on residual deformation characteristics of coarse-grained soils;
粗粒土动残余变形特性的试验研究
3.
On Improvement and Application of Shen-zhujiang Residual Deformation Model;
沈珠江残余变形模型的改进及其应用研究
补充资料：变形区长度
变形区长度
length of deformation zone
b ianxingqu ehangdu变形区长度(length of deformation:one) 轧制时轧件同轧辊接触弧的水平投影长度，一般以l表示，l=双sina，式中R为轧辊半径，a为咬入角。从几何关系还可以求得l与R及压下量从的关系为l /_.，从2，_劫2.__L___.，~~:，、，~=心R从一二笋.，由于岑~相对于R助小得多，故计算 V-一4’一一4’一’‘’--一一~一，一，·~中均用其近似值l、翻丫天瓦。 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条