1) Al-Pb alloy
Al-Pb合金
1.
Al-Pb alloy was modified by high current pulsed electron beam.
利用强流脉冲电子束技术对Al-Pb合金进行表面改性处理,测试改性试样表面硬度分布及其形貌和组织,采用销-盘式摩擦磨损试验机、扫描电子显微镜和X射线光电子能谱仪对改性Al-Pb合金的摩擦磨损性能及其磨损机理进行分析。
2.
A two-phase convective flow model describing the microstructure evolution during the liquid-liquid phase transformation in monotectic alloy was developed by taking into account of the convective effect and used in analyzing Al-Pb alloy.
建立了偏晶合金液-液相变过程中的两相流动模型,发展了偏晶合金凝固理论模型;以Al-Pb合金为例,模拟研究了偏晶合金凝固时的组织演变进程,考察了流动对凝固组织形成的影响。
3.
The effect of solute distribution causing by ultrasonic treating using the Al-Pb alloys was studied, measuring the samples by BSE and testing hardness and wearing property of samples.
本文以Al-Pb合金为研究对象,研究了超声波处理对合金铸锭溶质分布的影响。
2) Al-Pb alloys
Al-Pb合金
1.
Numerical simulation of rapid and directional solidification of Al-Pb alloys;
Al-Pb合金快速定向凝固的数值模拟
3) Al/Pb muti-layer foil
Al/Pb合金
4) aluminum lead alloy
Al-Pb系合金
5) Al-Si-Pb alloy
Al-Si-Pb合金
1.
Based on experimental investigation and physical models, the temperature field and stress field are simulated for Al-Si-Pb alloy.
在强流脉冲电子束改性实验基础上,通过数值计算方法对Al-Si-Pb合金的温度场和应力场进行模拟,给出了最先熔化的位置、形成熔坑的最大深度、熔化区的最大深度以及准静态热应力的分布。
6) Al-Pb-Cu alloy
Al-Pb-Cu合金
1.
The Al-Pb-Cu alloy was prepared by mechanically alloying.
用机械合金化方法制备了Al-Pb-Cu合金。
补充资料：Al-Li合金构件——歼7-II飞机舱口盖及副翼扰流片
Al-Li合金构件——歼7-II飞机舱口盖及副翼扰流片
Al—Ll合金构件——歼7一I 1机舱口盖及副翼扰流片 张自供稿
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条