1) TDI
TDI
1.
Exploiture of the Key Technique for Separation TDI from Polyurethane Curing Agent by Thin-film Evaporator;
用薄膜蒸发器分离聚氨酯固化剂中游离TDI关键技术开发
2.
Study on the Manufacture of Polyurethane Prepolymer with Low Content of TDI;
低游离TDI含量的聚氨酯预聚体制备研究
3.
Evaluation on the uncertainty of the test results of the TDI content in solvent-borne wood coatings;
溶剂型木器涂料中TDI含量测定结果不确定度评定
2) TDI
甲苯二异氰酸酯
1.
Brief Introduction to opportunities and challenges of developing domestic TDI products;
浅谈我国甲苯二异氰酸酯产品的发展机遇与面临的挑战
2.
Effects of TDI on Workers Health;
甲苯二异氰酸酯对作业工人的健康影响
3.
The process of phosgene-recirculation system in toluene diisocynate(TDI) production is analysed and two shortcomings of the old process are found:① High hydrogen chloride concentration of phosgene will decrease the reaction’s yield and ② The phosgene in the kettle under saturated state will become a potential hazard.
对甲苯二异氰酸酯(TDI)生产中光气循环系统流程进行了分析,认为原流程中存在两个缺点:①循环使用的光气中氯化氢含量过高,会降低反应收率;②光气罐中光气始终处于饱和状态,不利于安全。
3) TDI
甲苯-2,4-二异氰酸酯
1.
A novel series of nonionic water-borne polyurethane surfactants were prepared based on toluene diiosocynate(TDI),castor oil and polyethylene glycol(PEG) as raw materials.
采用甲苯-2,4-二异氰酸酯(TDI)、蓖麻油和聚乙二醇(PEG)等为主要原料,通过逐步聚合得到一种新型非离子水性聚氨酯表面活性剂,并利用红外光谱对其结构进行了表征。
2.
A series of nonionic water-borne polyurethane surfactants were prepared using toluene di-isocynate(TDI),castor oil and polyethylene glycol(PEG)as raw materials.
以甲苯-2,4-二异氰酸酯(TDI)、蓖麻油和聚乙二醇(PEG)等为主要原料,通过逐步聚合得到一种非离子型水性聚氨酯表面活性剂,并利用红外光谱对其结构进行了表征。
3.
In this paper, the conditions for synthesizing starc h -TDI copolymer emulsion were investigated, and the copolymer was characterized by FTIR spectra.
讨论了淀粉-甲苯-2,4-二异氰酸酯(TDI)共聚乳液的合成条件,并对其进行了红外光谱表征;实验表明,合成过程中预聚时间为2h,封闭时间为25min为宜。
4) TDI
二异氰酸甲苯酯
1.
Investigation and analysis on hazards of TDI in a chemical plant;
某化工厂二异氰酸甲苯酯危害调查分析
2.
Study on Health of Workers Exposed to Low Concentration of TDI;
接触低浓度二异氰酸甲苯酯工人的健康研究
5) TDI
甲苯-2,4二异氰酸酯(TDI)
6) TDI
甲苯-2,4-二异氰酸酯(TDI)
参考词条
补充资料:TDI
分子量174.16
性质 无色至淡黄色透明液体,有强烈刺激性气味。密度1.22g/cm3。凝固点13.2℃。沸点118-120℃(12.7×103Pa)。闪点12l℃。溶于醚、丙酮及其他有机溶剂。与水反应生成二氧化碳。能与含活泼氢的化合物反应,具有很高的活性。遇明火能燃烧,受高热分解放出有毒气体。有毒,对皮肤、眼睛、粘膜有强烈的刺激性。空气中最高容许浓度0.02ppm。
应用 主要作为聚氨酯树脂的生产原料,用于生产聚氯酯泡抹塑料、涂料、橡胶、粘合剂、密封剂等。也可用作橡胶硫化剂、蛋白质交联剂等。
性质 无色至淡黄色透明液体,有强烈刺激性气味。密度1.22g/cm3。凝固点13.2℃。沸点118-120℃(12.7×103Pa)。闪点12l℃。溶于醚、丙酮及其他有机溶剂。与水反应生成二氧化碳。能与含活泼氢的化合物反应,具有很高的活性。遇明火能燃烧,受高热分解放出有毒气体。有毒,对皮肤、眼睛、粘膜有强烈的刺激性。空气中最高容许浓度0.02ppm。
应用 主要作为聚氨酯树脂的生产原料,用于生产聚氯酯泡抹塑料、涂料、橡胶、粘合剂、密封剂等。也可用作橡胶硫化剂、蛋白质交联剂等。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。