1) non-electrolyte water solution
非电解质水溶液
2) Nonaqueous electrolyte solution
非水电解质溶液
3) heterogeneous aqueous electrolyte
非均相电解质水溶液
1.
A conventional adiabatic calorimeter was constructed and the specific heat capacities of 7 heterogeneous aqueous electrolytes have been measured at the temperatures from 5 ℃to 60 ℃.
制备了一个简易绝热型热量计，并用此热量计实测了 ７ 种非均相电解质水溶液在 ５～６０℃范围内不同温度区间的比热容，提出了比热容与温度的经验关联式⒚关联式的计算值和实验值的平均相对偏差均小于 １％ ⒚热量计采用标准物质正庚烷标定，装置的测量精度为 ０。
4) non electrolyte solution
非电解质溶液
1.
Based on Eyring's theory of rate processes and introducing local surface fraction, a three parameter equation of calculating viscosity for non electrolyte solutions has been proposed.
依据 Eyring的反应速度理论 ,引用局部表面积分数 ,得到了预测非电解质溶液粘度的三参数方程 ,提出了参数与温度的关系式。
2.
Based on Chapmans theory of heat conduction for correlating liquid thermal conductivity with viscosity,and combined a correlative formula of liquid viscosity which is induced from Eyrings theory of rate processes and introducing local surface fraction,a new equation of calculating thermal conductivity for non electrolyte solutions has been proposed.
依据Ｃｈａｐｍ ａｎ 导热理论关于液体导热系数与粘度的关系，结合由Ｅｙｒｉｎｇ 反应速率理论及引入局部面积分数而导出的液体粘度关联式，得到了一个计算非电解质溶液导热系数的新方法。
5) electrolysis of nonaqueous solution
非水溶液电解法
1.
A new analysis method is introduced on inclusions in steel in this paper,by the method of electrolysis of nonaqueous solution associated with RTO metal embeds cutting film micron-nano token method.
研究了一种采用非水溶液电解法与RTO金属包埋切片微米-纳米表征法联合分析钢中非金属夹杂物的新方法,该方法全过程对夹杂物不产生任何损伤破坏作用。
6) non-aqueous solution electrolysis
非水溶液电解
1.
The inclusions are first separated by the non-aqueous solution electrolysis,and then the morphology and compositions of extracted inclusions are determined by SEM/EDS.
采用非水溶液电解法从钢中分离夹杂物,并用SEM/EDS分别对其形貌和成分进行检测,获得典型夹杂物的分布规律。
补充资料：电解沉积(见水溶液电解)
电解沉积(见水溶液电解)
electrowinning
d lanJ一e ehenji电解沉积(eleetrowinning)见水溶液电解。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条