1) stress intensification factor
应力增强系数
1.
Calculation method on stress intensification factor of hem pyramidal head that mentioned in GB 150—1998《Steel Pressure Vessels》was derived and analyzed.
推导分析了GB 150-1998《钢制压力容器》中折边锥形封头应力增强系数K的确定方法。
2.
The research of stress intensification factor for large diameter piping system was carried out in this paper.
对大直径管道系统的应力增强系数SIF进行了研究,利用有限元方法计算了大直径管道标准三通,并将ASME B31规范的计算结果与FE/PIPE的结果进行了比较。
2) dynamics strengthen coefficient
动力增强系数
3) stress intensification factor
应力增大系数
1.
The accurate formula to calculate the stress intensification factors was given when stress classification check was applied.
以大型减压转油线为研究对象,针对大型管道中常见的Y型三通及相连管线进行应力分析,采用了将应力分类进行校核的方法,给出了准确计算应力增大系数的计算公式。
2.
Through large amount of calculations based on finite element analysis,the stress intensification factors for welded branch inside and outside of the plane were obtained,which corrected the problem that the data given in B31.
通过大量的有限元计算,得出了关于焊接支管之平面内、外应力增大系数,弥补了在d/D>0。
4) complex stress intensity coefficient
复应力强度系数
5) stress intensity coefficient
应力强度系数
1.
Influence of rolling contact fatigue loads on stress intensity coefficients of rail surface contact fatigue crack
滚动接触疲劳载荷对铁轨表面接触疲劳裂纹应力强度系数的影响
2.
A numerical method for determination of multiple stress singularity orders and corresponding stress intensity coefficients is presented in this paper, by the example of plane problems with two stress singularity orders, based on the numerical solutions obtained by common numerical procedures such as FEM and BEM.
以具有两个应力奇异性次数的平面问题为例 ,提出了一种利用普通的数值分析结果确定奇异点附近多重应力奇异性的各阶次数以及相应的应力强度系数的数值分析方法。
6) strengthening adaptability
增强适应力
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条