1) ammonium sulfate
硫铵
1.
Barrel type drier with processing capacity of 3t/h~5t/h and the water content in ammonium sulfate below 0.
该干燥器自投运后,系统运行稳定,节约能耗,硫铵水分最低0。
2.
The synthesis process of potassium sulfate with ammonium sulfate recovered from industrial waste and potassium chloride method was studied.
介绍一种回收富含硫铵化工废水制备硫酸钾肥的方法。
3.
The paper introduces the four kinds of production process of ammonium sulfate,and analyzes and discusses the process features,technology and economic index and equipment selection.
本文介绍了四种硫铵生产工艺 ,并从工艺特点 ,技术经济指标 ,设备选材等方面进行分析比较和评述。
2) ammonium sulphate
硫酸铵(俗称硫铵)
3) Ammonium thiosulfate
硫代硫酸铵
1.
Direct determination of gold in ammonium thiosulfate solution by AAS;
原子吸收法直接测定硫代硫酸铵溶液浸金系统中金的研究
2.
MoO3/γ-Al2O3 catalyst has been presulfided by ammonium thiosulfate.
以硫代硫酸铵为硫化剂对MoO3/Al2O3催化剂进行预硫化,考察了制备方法和活化条件对预硫化催化剂噻吩加氢脱硫活性的影响。
3.
The isothermal phase diagrams of the system were constructed on the basis of the mass fractions of water,ammonium sulfate and ammonium thiosulfate saturated solution at 298 K.
依据水、硫酸铵及硫代硫酸铵组成的饱和溶液各组分的质量分数绘制了(NH4)2S2O3-(NH4)2SO4-H2O在298 K下的三元体系相图。
4) ammonia-ammonium sulfate
氨-硫酸铵
1.
Study on arsenic removal in the preparation of feed grade zinc oxide by ammonia-ammonium sulfate method;
氨-硫酸铵法生产饲料级氧化锌中除砷工艺研究
5) ammonium thiocyanate
硫氰酸铵
1.
Study on liquid-solid flotation separation of lead(Ⅱ) by sodium nitrate-ammonium thiocyanate-rhodamine 6G system;
硝酸钠-硫氰酸铵-罗丹明6G液-固体系浮选分离铅(Ⅱ)的研究
2.
Study on floatation separation of Pd(Ⅱ) with ammonium thiocyanate-tetrabutyl ammonium bromide-water system;
溴化四丁基铵—硫氰酸铵—水体系浮选分离钯(Ⅱ)的研究
3.
Floatation separation of copper in sodium chloride-ammonium thiocyanate-cetylpyridine bromide system;
氯化钠-硫氰酸铵-溴化十六烷基吡啶体系浮选分离铜(Ⅱ)
6) ammonium persulphate
过硫酸铵
1.
In light of the principle of vanadium's valent state change,after samples are dissolved by weak nitric acid,in medium of around 15% nitric acid,the oxidant ammonium persulphate is immediately used to selectively oxidize V~(4+) to V~(5+).
利用钒的价态变化原理,试样以稀硝酸溶解后,在15%左右的硝酸介质中,直接用氧化剂过硫酸铵选择性地氧化V~(4+)为V~(5+)。
2.
With industrial monomer solution of dimethyldiallylammonium chloride(DMDAAC) as raw material,ammonium persulphate(APS) as initiator and Na_4EDTA as chelating agent,using the methods of adding initiator all at once,graduated increasing of temperature and stepwise initiation and polymerization,the polymerization process of preparing poly-dimethyldiallylammonium chloride(PDMDAAC) was researched.
以一步法工业单体二甲基二烯丙基氯化铵(DMDAAC)为原料,以过硫酸铵(APS)为引发剂,采用一次性加入引发剂,梯度升温,分步引发水溶液聚合反应的方法,对制备聚二甲基二烯丙基氯化铵(PDMDAAC)的聚合反应的工艺进行了优化研究。
3.
Poly-dimethyldiallylammonium chloride(PDMDAAC)was prepared by using industrial dimethyldiallylammonium chloride(DMDAAC)aqueous solution with known impurities as starting material,ammonium persulphate(APS)as initiator,without addition of any transferring and terminating agents.
以过硫酸铵(APS)为引发剂,以已知杂质含量的工业一步法合成的二甲基二烯丙基氯化铵单体溶液为原料,采用水溶液聚合法,无需使用链转移剂和链终止剂,通过控制单体的起始含量(w(DMDAAC)=35。
补充资料:硫铵
分子式:(NH4)2SO4
分子量:132.13
CAS号:7783-20-2
性质:暂无
制备方法:暂无
用途:暂无
分子量:132.13
CAS号:7783-20-2
性质:暂无
制备方法:暂无
用途:暂无
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条