1) corner unit cell model
棱角单胞
2) edges and corners
棱角
1.
An anodizing technology was used in anodic oxidation of aluminum alloy, chemical immersion test and drop test were used to test corrosion resistance of the oxide film, and electron probe was used to analyze the oxide film morphology at edges and corners.
对铝合金进行阳极氧化,并进行化学浸泡试验和点滴试验,用电子探针观察棱角部位氧化膜的形貌。
2.
Started with studying on the morphology of LY12 aluminum alloy anodic oxide film at edges and corners and combined with chemical immersion test and drop test, the morphology of oxide film is observed at edges and.
本文主要研究LY12型铝合金的阳极氧化工艺,着重解决在弱酸性燃料电池工作环境中,提高铝合金棱角部位耐蚀性能。
3) regular hexagonal cell
六角形单胞
1.
The mathematical model of the specific on resistance with the regular hexagonal cell power VDMOSFET is introduced in this paper.
介绍了六角形单胞功率VDMOSFET特征导通电阻的数学模型 ,计算了不同漏源击穿电压下 ,各种电阻分量在特征导通电阻中所占的比例 ,分析了阻值随电压变化的原因 。
4) angle
[英]['æŋɡl] [美]['æŋgḷ]
角;棱;角度
5) U. salicorniae
盐角草单胞锈菌
1.
blainvilleae and U.
blainvilleae和盐角草单胞锈菌U。
6) chamfer angle
倒棱前角
1.
Influences of chamfer angle of PCBN cutting tool on the cutting forces and tool wear in dry turning hardened steel;
PCBN刀具干车淬硬钢时倒棱前角对切削力和刀具磨损的影响
2.
This paper presents a study on dry turning hardened steel GCr15 with PCBN cutting tool, and the relations between surface roughness, chip form and the chamfer angle were obtained, furthermore, the inherent cause of that was analyzed.
通过对PCBN刀具硬态干切削淬硬轴承钢GCr15试验的研究,分析得出工件表面质量与倒棱前角及切屑形态与倒棱前角之间的关系,进而剖析了这一关系的内在成因,得出在实际加工中推荐选用的倒棱前角值。
补充资料：棱角烧肉
原料：
五花肉200克、棱角肉50克、姜10克、蒜子10克、香葱10克。
调味料：
花生油50克、盐10克、味精12克、白糖5克、老抽王8克、湿生粉适量、清汤100克。
制作过程：
1、五花肉去净毛切块，姜切片，蒜子切去二头，葱切段。
2、烧锅下油，放入五花肉，用小火炒至有香味。
3、加入清汤、盐、味精、白糖、老抽王、棱角肉，用小火烧至浓汁熟透时，再用湿粉打芡，铲入碟内。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条