1) groove type
坡口形式
1.
It is the key to ensure the quality of the weld that adopted reasonable groove type according as the chemical compositions of the approachable side of clad steel plate.
试验结果表明,复合钢板焊接时,可接近的侧面和钢板厚度将决定焊接顺序和焊接材料的选用,而根据可接近侧面材质设计合理的坡口形式,是保证复合钢板焊接质量的关键。
2.
On account of the effect of the rate of dilution on the quality of welded joint of dissimilar steels, the relationship among the rate of dilution, groove type and welding technology was examined and analyzed.
异种钢焊接的稀释率对焊接质量有影响,通过焊缝的稀释率与接头坡口形式、焊接工艺关系试验与分析,采用试验推荐的坡口形式及焊接参数可将焊缝稀释率控制在所要求的范围内。
2) groove shape
坡口形式
1.
This paper presents a thorough study of the effect of groove shapes X & V on the mechanical properties of the different matching welded joints, including impact toughness, hardness and tensile strength.
研究了Ｘ、Ｖ型两种不同的坡口形式对不同匹配的压力容器用钢１６ＭｎＲ对接接头的冲击韧度、硬度、抗拉强度等力学性能的影响。
2.
The effects of groove shapes of I,U .
报导了具有I、U、双U和V型四种坡口形式对7mm的45CrNiMoV高强度钢板材对接焊缝性能影响的研究。
3) I shaped groove
I形坡口
4) single U groove
U形坡口
5) double-Vee groove
X形坡口
补充资料：坡陁
1.亦作"坡陀"。 2.山势起伏貌。 3.不平坦。 4.山;山坡。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条