Analysis on the Raw Material Air-compressor in the Low Pressure Methanol Device and Its Innovation;

Implementation of net connection before chlorine gas compressor of two period ionic membrane electrolysis;

The application of dry gas seal on circulating hydrogen compressor of 1200 kt/a hydrogenation cracking equipment;

Study on Theory and Application of Intelligent Condition Monitoring for Compressors;

This paper illustrates the frame of the calculation and analysis software for the energy-saving of the reciprocating compressors in synthetic ammonia system.

In order to increase equipment efficiency and avoid contingent failure,lubricating oil monitoring scheme was planned,samples were collected,iron-spectrum analysis device was used to monitor the abrasive particles in the lubricating oil according to plant compressors conditions in Dalian Petrochemical Corporation.

Part improvement of YV - 6/8 type air compressor;

Remote Monitor-Control System for Air Compressor Based on Ethernet Controller 7188E;

The test result shows the model has advantages in predicting the monitoring of air compressor.

The communication technology research of reciprocating compressor monitoring system based on MPI;

According to the working status quo of large scale 6 cylinders M-style reciprocating compressor,this paper introduces a monitoring system based on the hardware structure of "SENSOR-PLC-IPC".

The parameter design of reciprocating compressor is very difficult because of its complicated structure and variety.

Installation Without Iron Padding Block and Stressless Pipeline Connection of the Compressor Set in a 600kt/a Methanol Alcohol Plant;

This paper introduced the basic principle, the system constitute,technique constituting and operation mode of actualizing state monitor and fault diagnosis technology to compressor set,discussed the possibility and importance towards large and on-line equipments put appearance into practice state monitor and fault diagnosis technology.

Oil flushing for the lubricating oil system of a compressor set is an important working procedure prior to putting the compressor set into operation.

The 28AT dry gas seal set and its inspection and control system of the CO2 compressor in Jianfeng Fertilizer Factory were introduced.

This paper analyzes the reasons for high lubricant oil consumption of the 2nd phase CO2 compressor of a certain company;describes through improving oil sealing,fixing control switch on the coupling oil inlet pipe,reducing the suction of oil mist fan and improving high pressure air duct,etc.

The paper analyzes the problems that made CO2 compressor discharge not enough,which turns out the design defects of first inter-cooler that caused flow resistance too high.