1) abrasive size
磨料粒径
2) abrasive grain size
磨粒粒径
1.
Experiments were taken to investigate the effect of abrasive grain size on the lapping uniformity of sapphire wafer,macro and micro surface profiles were measured and compared by contact and contactless measurement methods.
测试分析结果表明:磨粒粒径的选择对蓝宝石的研磨表面状态具有重要影响,其选择准则除考虑要达到的粗糙度等级之外,还必须同时考虑与研磨盘的嵌入作用及其对加工表面状态的影响;W3。
3) abrasive size
磨料粒度
1.
The change of abrasion resistant of epoxy adhesive coating in different abrasive sizes and different concentrations are studied when it was eroding.
研究了环氧胶粘涂层在不同的磨料粒度和浆体浓度下冲蚀磨损时耐磨性能的变化,对比了T-31、低分子聚酰胺两种固化剂和粉煤灰、有机蒙脱土两种填料对环氧胶粘涂层性能的影响,探讨了纳米粒子在环氧胶粘涂层中的作用,推荐了纳米环氧胶粘涂层的最佳配方。
4) abrasive particles
磨料颗粒
1.
Analysis of forces acting on abrasive particles in abrasive water jet;
磨料水射流中磨料颗粒的受力分析
2.
The methods used to monitor the abrasive particles suction process,the water orifice condition,the focus tube condition and wear were reviewed and their advantages and disadvantages were also analyzed,respectively.
综述了磨料水射流工艺控制过程的最新研究与进展;分别介绍了磨料颗粒吸入过程、水喷嘴状况和准直管工作状况以及磨损控制等方面的进展,并分析了各种方法的优缺点;提出了采用专家系统来监测切割过程中多个参数变化以优化切割过程的方法。
3.
The control equations for both the abrasive particles and the rock were also provided.
根据连续介质力学和有限元理论,给出了磨料水射流破岩系统中磨料颗粒和岩石的控制方程及相应的有限元列式,建立了适用于磨料水射流破岩全过程分析的岩石损伤模型。
补充资料：调和平均粒径
分子式：
CAS号：
性质：在混合颗粒中，直径为d1、d2、…dn的颗粒的质量分率，分别为x1、x2、…xn，则混合颗粒的调和平均直径可按下式计算：
CAS号：
性质：在混合颗粒中，直径为d1、d2、…dn的颗粒的质量分率，分别为x1、x2、…xn，则混合颗粒的调和平均直径可按下式计算：
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条