1) water vapor permeability (WVP)
透湿系数
1.
The influ- ences of protein concentrate,glycerol concentrate,and heating temperature on film properties,such as water vapor permeability (WVP) and oxygen permeability (OP) were studied.
响应面分析表明,当蛋白质浓度为100 g/L,甘油浓度为27 g/L,加热温度为69℃时,乳清浓缩蛋白可食用膜的综合通透性能为最佳,其透湿系数为0。
2) water permeability coefficient
湿迁移渗透系数
1.
The transport behavior of chloride ion,water and air in concrete after fire,as well as the effect of temperature,strength grade and aggregation on permeability of HSC after fire were investigated in terms of chloride ion permeability coefficient,water permeability coefficient and air permeability coefficient.
采用氯离子渗透系数、湿迁移渗透系数与空气渗透系数研究了氯离子、水与空气3种不同介质在受高温后混凝土中的传输行为,以及温度、强度等级、骨料种类对HSC高温后渗透性能的影响。
3) water vapor permeability coefficient
水蒸气透湿系数
1.
The polystyrene foam plastics is one of the most widespread materials of applying in external insulation outside wall system,water vapor permeability coefficient affects its heat conduction performance and aging resistance performance,but test methods of the coefficient in its product standards aren t suitable for the test and the conclusion evaluation of this material.
聚苯乙烯泡沫塑料是外墙外保温系统应用最广泛的材料之一,水蒸气透湿系数影响其导热性能和耐老化性能,而其产品标准中所采用的检验方法不适合于该材料的检测和结论评定。
4) impermeability index
透湿指数
1.
At last, influences of the suit thermal resistance and impermeability index to body hot load ware analyzed with the modal built above.
最后利用所建模型分析服装热阻及透湿指数对人体热负荷的影响。
5) wetness factor
湿度系数
6) coefficient of collapsibility
湿陷系数
1.
Several affecting factors determining loess coefficient of collapsibility;
影响黄土湿陷系数测定的几个因素
2.
In this paper,the loess coefficient of collapsibility was tested by using circular knife of 30cm2 and 50cm2 in laboratory,then the difference of coefficient of collapsibility between vertical and lateral of loess was compared.
试验所用黄土试样取自西安东郊十里铺,且试样均在同一探井4m深度处取得,属Ⅲ级自重湿陷性黄土,在室内分别用面积为30cm2(小环刀)和50cm2(大环刀)的环刀进行单、双线法湿陷性试验,同时用相同含水量的黄土试样在平行于黄土的沉积方向(纵向)和垂直于黄土沉积方向(横向)进行湿陷试验,最后得出了环刀面积和黄土的各向异性对其湿陷系数影响很大的结论。
3.
The structural strength, compression curve, coefficient of collapsibility under different water content and coefficient of consolidation of natural saturated loess and man made structural loess are measured with confined compression test in lab.
通过室内侧限压缩试验 ,对原状黄土和人工制备结构性黄土测定了不同含水量下的结构强度、压缩曲线、湿陷系数及饱和时的固结系数。
补充资料：透湿量
分子式：
CAS号：
性质：又称水蒸气透过量或透湿量。塑料薄膜或片材两侧存在水蒸气压力差时，在一定温度下透过的水蒸气量以g/(m2·24h)表示。用杯式法测量。装好试样的透湿杯放在一定条件的环境中，如相对湿度为90％±2％，温度28℃，进行水汽透过。杯中有干燥剂，可以认为水蒸气压力为零。经过一定时间，干燥剂吸收透过的水蒸气而增重，根据增重的量，水蒸气透过率WVT=24×△m/A·△t，式中△m是T时间内的质量增重，g；△t是质量增量稳定后，两次测重间隔时间，h；A是试样透过水蒸气面积，m2。
CAS号：
性质：又称水蒸气透过量或透湿量。塑料薄膜或片材两侧存在水蒸气压力差时，在一定温度下透过的水蒸气量以g/(m2·24h)表示。用杯式法测量。装好试样的透湿杯放在一定条件的环境中，如相对湿度为90％±2％，温度28℃，进行水汽透过。杯中有干燥剂，可以认为水蒸气压力为零。经过一定时间，干燥剂吸收透过的水蒸气而增重，根据增重的量，水蒸气透过率WVT=24×△m/A·△t，式中△m是T时间内的质量增重，g；△t是质量增量稳定后，两次测重间隔时间，h；A是试样透过水蒸气面积，m2。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条