1) gas injection
注气
1.
Axial displacement comparative analysis of the tubing string in the gas injection wells.;
注气井中油管轴向位移计算比较分析
2.
Phase state characteristic after gas injection into formation oil based on computational method;
基于计算方法的地层油注气后相态特征
3.
The numerical simulation study on gas injection development for the low-permeability reservoir of Chun-107-fault new block;
纯107块低渗透油藏注气开采数值模拟研究
2) gas cap repressuring
气顶注气
3) gas-gas injector
气-气喷注器
1.
Experimental investigation of flowrate characteristics of gas-gas injector;
气-气喷注器流量特性实验研究
4) gas/gas injector
气气喷注器
1.
To facilitate hot-fire tests of single element gas/gas injector chamber,a method used to reveal the combustion development and completion length of the chamber flowfield was designed,which combines wall temperature measurement and numerical simulation of gas/gas combustion flowfield.
为了方便开展单喷嘴气气喷注器燃烧试验研究,设计了一种燃烧室壁面测温,并结合推力室燃烧流场的非稳态数值模拟的方法,以考察燃烧室内流场的发展和燃烧完成情况。
5) gas flow
注气流量
1.
On the basis of experiments,the factors which influenced the shape of PA12 double-lumen catheter cross-section in process of extrusion,including the die temperature,the screw rotational speed,the tractive rate and the volumetric gas flow were analyzed.
在实验的基础上,分析了聚酰胺(PA)12双腔医用导管挤出过程中机头温度、螺杆转速、牵引速率和注气流量对导管截面形状精度的影响。
2.
In this dissertation, gas flow controller system was designed.
为得到较好的导管截面形状,本文从材料的流变特性、机头设计、注气流量的控制以及挤出工艺参数的调节四个方面进行了实验研究,得出的结论对双腔导管的挤出成型有一定的参考作用。
6) air injection
注空气
1.
EOR technology of air injection to light oil reservoir;
轻油注空气提高采收率技术
2.
LTO laboratory experiments and reservoir selection criteria of air injection;
注空气低温氧化驱油室内实验与油藏筛选标准
3.
Combustion-tube test of air injection for light-oil reservoir;
轻质油藏注空气燃烧管试验
补充资料：注气开采
见注水开采。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条