1) dense phase carbon dioxide
密相CO2
1.
In this work,the effects of ultrasonic power density and frequency as well as extraction temperature,pressure,time and CO_2 flow rate on the ultrasound-enhanced dense phase carbon dioxide extraction(UDCE) of sunflower seed oil are evaluated.
进行了超声强化密相CO2萃取葵花籽油的研究,探讨了萃取温度、压力、时间、CO2流速以及超声功率密度和频率对葵花籽油萃取率的影响。
2) dense phase
密相
1.
Design of air conveying system of tank trailer dense phase replenish gas type;
槽车密相补气式气力输送系统的设计
2.
The axial size of dense phase in downer was about 10—15 mm, which was as large as tens times to one hundred times of pa rticles diameter.
实验结果显示:稀密两相时间分率的径向分布中心区域比较均匀,变化范围在10%~20%之间;轴向密相尺寸在十几毫米之间,密相内颗粒平均浓度为床层浓度的1。
3.
The concentration distribution of the dense phase in a turbulent fluidized bed, whose heightis 5 500 mm and inside diameter is 200 mm,was measured continually with gas chromatography.
在内径200mm,高5500mm的流化床内,采用点源反向示踪的方法,利用气相色谱分析仪连续取样分好了湍动流化床内密相的浓度分布。
3) thick phase
密相
4) Dense-phase
密相
1.
This paper investigated the pressure drops for horizontal pipes in dense-phase pneumatic conveying of pulverized coal under high pressures through experiments and theoretic calculation.
通过试验和理论计算两种方法研究高压下煤粉密相气力输送水平管稳定段的压力损失情况。
5) dense
密相
1.
Analysis of dense,turbulent,compressible,gas-particle two-phase flow and its application to pipe flow;
密相、湍流、可压、气固两相流理论及在管道中的应用
2.
The dilute compressible gasparticle flow over t he sand bed, the dilute and dense liquidsolid upflow in the pipe and the dense compressible gasparticle flow in blade pressure expander are simulated, the d i f ferent distributions of volumetri.
其次计算了沙层上的稀相可压气固两相流、直管内的不可压液固两相流及叶片扩压器中的密相可压气固两相流的流动,发现了颗粒浓度两种截然不同的分布,并验证了用不可压或稀相的模型来计算可压或密相的模型会带来误差,说明了在计算可压密相两相流动时,可压及密相的因素必须考虑到。
3.
A CDIPSAR algorithm on compressible and dense gas solid two phase turbulent flow is developed.
在DIPSAR算法的基础上 ,推导了适用于可压密相气固两相湍流流动数值计算的CDIPSAR算法 。
6) rich phase
密相
参考词条
补充资料:密相
分子式:
CAS号:
性质:也称浓相或密相。在流化床分布器区的上方颗粒密度最大的颗粒相。这部分称富相区或浓相区,差不多全部颗粒都在这里流化,是床层中颗粒密度最大的地方。富相层的高度也称为流化床层的高度,它与静止时固体颗粒床层的高度之比,称为膨胀比。这是流化床设计中的一个很重要的参数。
CAS号:
性质:也称浓相或密相。在流化床分布器区的上方颗粒密度最大的颗粒相。这部分称富相区或浓相区,差不多全部颗粒都在这里流化,是床层中颗粒密度最大的地方。富相层的高度也称为流化床层的高度,它与静止时固体颗粒床层的高度之比,称为膨胀比。这是流化床设计中的一个很重要的参数。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。