1) polymerization stability
聚合稳定性
1.
Studies on kinetic and polymerization stability of emulsion polymerization of MMA using urethane acrylate as polymerizable emulsifier;
聚氨酯预聚体——可聚合乳化剂用于MMA乳液聚合动力学及聚合稳定性研究
2.
The test results on emusilon and film properties showed that with increase of amount of OVS,the Tg,tensile strength and water resistance of film are improved significantly,while the polymerization stability and rupture elongation decreased slightly.
对乳液性能和涂膜性能的测试结果表明:随着多面体低聚倍半氧烷(POSS)含量的增加,涂膜的玻璃化转变温度、拉伸强度和耐水性显著提高,而聚合稳定性和断裂伸长率有所下降。
3.
The effects of NCO/OH molar ratio, composite emulsifier concentration, different emulsifiers, initiator concentration, volume fraction of the monomer phase (Φ) and temperature on the polymerization stability and kinetics of the concentrated emulsion were investigated.
研究了以非离子型可聚合聚氨酯(PUAG)和苯乙烯(St)为混合单体的超浓乳液聚合,并且考察了n(NCO)/n(OH)摩尔比、复合乳化剂体系质量浓度[E]、不同乳化剂的种类、引发剂质量浓度[I]、单体体积分数(或分散相体积分数,也称内相比Φ)、聚合温度等因素对聚合稳定性、动力学的影响。
2) nitrogen-oxide stabilization free radical
活性稳定自由基聚合
3) terminator
[英]['tə:mineitə] [美]['tɝmə,netɚ]
聚合稳定剂
4) retarder
[英][ri'tɑ:də] [美][rɪ'tɑrdɚ]
聚合稳定剂
5) agglomerative stability
团聚稳定性
1.
The sedimental stability, agglomerative stability and thermal stability of magnetorheological fluid made bycrabonyl iron powder and mineral oil or silicone oil were studied and investigated, the influence factor on the stabilitywere also discussed.
本文对所研制的矿物油系和硅油系磁流变体样品的温度稳定性、沉降稳定性、团聚稳定性、二次悬浮性进行了系统的测试和分析,并对其影响因素进行了详尽的讨论。
6) coagulation stability
聚结稳定性
补充资料：连续性与非连续性(见间断性与不间断性)
连续性与非连续性(见间断性与不间断性)
continuity and discontinuity
11an父ux泊g四f“山。麻以角g、.连续性与非连续性(c。nt，n琳t:nuity一)_见间断性与不间断性。and diseo红ti-
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条