1) Slit Mold
切缝式结晶器
1.
Penetration of Magnetic Field and Cooling Effect in Two-stage Mold and in Slit Mold for Soft-contact Electromagnetic Continuous Casting;
利用数值模拟考察了软接触电磁连铸用两段式结晶器与切缝式结晶器的透磁效果和冷却效果。
2) Two-section Slitless Mold
两段式无缝结晶器
1.
Prediction of Meniscus Shape in Two-section Slitless Mold for Soft-contact Electromagnetic Continuous Casting;
通过理论分析,得到软接触电磁连铸结晶器内部金属液弯月面形状的计算公式,并根据试验结果进行了修正,修正后的公式可较准确地计算两段式无缝结晶器内部金属液的弯月面形状。
3) slit-less mold
无缝结晶器
1.
The experimental measurement and numerical simulation were used to study the magnetic field distribution in the two-stage soft contact electromagnetic continuous casting slit-less mold.
通过实验测试和数值模拟的方法研究两段式软接触电磁连铸无缝结晶器结构、线圈位置、电源功率以及弯月面位置等因素对结晶器内高频磁场分布的影响。
4) cooling water slit of mould
结晶器冷却水缝
5) tube mould
管式结晶器
1.
The design aspects of the big bloom tube mould has been introduced in the present paper,which is helpful for the consideration of steel producers.
本文介绍大型管式结晶器的设计特点与经验,以供用户和同行参考。
6) combined mold
复式结晶器
1.
The effect that combined mold can increase the proportion of equiaxial crystal of billet was confirmed by comparing its heat transfer character with that of traditional mold and measuring the macrostructure of the billets produced by these two molds.
为了验证复式结晶器在提高铸坯等轴晶率方面的作用,分析比较了复式结晶器和传统结晶器的传热特征,并检测了两种结晶器所浇注铸坯的宏观组织。
2.
The temperature field of the nonmetallic material of combined mold was measured using thermocouples at different place of mold to get the heat flux distribution in mold.
为了检测结晶器的热流分布,在复式结晶器非金属材料段不同位置埋设热电偶,测定了结晶器的温度场,并在此基础上建立了描述复式结晶器内方坯凝固过程的三维数学模型。
补充资料：缝式
缝式 seam
两层或多层缝料的缝合经不同方式折叠后缝合的型式。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条