1) FRP
纤维布
1.
Strengthening Effect of Different FRP Confined Reinforced Concrete Columns;
不同纤维布约束钢筋混凝土柱的加固效果分析
2.
Calculation Method on Bending Crack in RC Beams Strengthened with FRP;
粘贴纤维布加固RC梁的受弯裂缝计算方法
3.
Time-dependent reliability analysis of existing bridges strengthened with FRP laminates;
既有桥梁外贴纤维布加固后可靠度分析
2) fiber cloth
纤维布
1.
Study on application of fiber cloth treated by plasma in cement mortar;
等离子体改性纤维布在水泥砂浆中的应用研究
2.
Several kinds of different Fanglun fiber cloth pulling experiment;
几种不同芳纶纤维布拉伸试验
3.
Amorphous nanoparticle titania(TiO_2) colloid immobilized on fiber cloth was prepared as a photocatalyst.
采用涂膜法直接将非晶态纳米TiO2胶体负载于纤维布上,制备了纳米TiO2光催化剂。
3) fiber reinforced polymer
纤维布
1.
Nonlinear analysis for the behaviors of the fiber reinforced polymer-confined reinforced concrete different columns cross-section is studied by using the large general structural analysis software ANSYS and destroy formation and resultant mechanization are discussed in the paper.
采用ANSYS对不同截面形状的纤维布约束钢筋混凝土柱的轴心受压性能进行了非线性数值分析,研究了纤维布约束钢筋混凝土不同截面形状柱的破坏形态和受力机理,结果表明:截面形状对加固柱的加固性能有明显影响,在实际工程中柱截面形状宜优先选用倒圆角截面。
2.
Nonlinear analysis for the behaviors of the fiber reinforced polymer—confined reinforced concrete columns under axial loads is studied by using the large general structural analysis software ANSYS in the paper.
采用ANSYS对纤维布约束钢筋混凝土柱的轴心受压性能进行了非线性分析,并与试验结果进行了比较。
3.
Optimial ansysis of reinforcement parameter for the behaviors of the fiber reinforced polymer-strenthening reinforced concrete columns under axial loads is studied by using the large general structural analysis software ANSYS in the paper.
采用ANSYS对纤维布加固钢混凝土轴心受压柱的加固参数进行了优化分析,并与试验结果进行了比较。
4) FRP sheet
纤维布
1.
Experimental study on relationships of strain in FRP sheet versus pulling force applied on FRP strengthened masonry;
FRP加固砌体拉拔力与纤维布应变关系的试验研究
2.
Experimental research on timber columns strengthened with FRP sheets
通过纤维布加固木柱的轴心抗压试验,研究纤维布的种类(碳纤维、玻璃纤维)、粘贴胶体的种类、纤维布的裹贴方式、粘贴层数等参数对木柱强度的影响。
5) FRP sheets
纤维布
1.
The paper analysed how the externally bonded FRP sheets work in the reinforcement of reinforced concrete piers.
分析了外包增强纤维布加固钢筋混凝土柱作用机理,介绍了工程中纤维布加固工序。
2.
Numerical Simulation and Theoretical Analysis of RC Beams Strengthened with Non-prestressed and Prestressed FRP Sheets;
数值分析表明,对于非预应力FRP布加固梁来说,粘贴FRP布后,加固梁的屈服荷载和极限荷载均有所提高,其中极限荷载的提高更为显著;在其他加固条件相同时,随着贴布层数的增加,加固构件承载力明显增加,但并不是线性关系;经纤维布加固的梁纯弯段内弯曲裂缝数量多,且间距小于未加固梁;加固梁的挠度均小于未加固梁的挠度。
6) fiber distribution
纤维分布
1.
Effect of fiber distribution uniformity on the mechanical properties of composite laminates;
纤维分布均匀性对T300/BMP316复合材料层压板力学性能的影响
2.
Discussion of Fiber Distribution of Soybean Protein Fiber Polyester Blended Yarn;
大豆蛋白涤纶混纺纱纤维分布探讨
3.
The fiber distribution of reinforced nylon air intake manifold is analyzed by MPI numerical simulation software.
运用数值模拟软件MPI对增强尼龙进气歧管的纤维分布进行优化,利用浇口分析模块确定其最佳浇注位置,并通过调整注塑工艺参数值比较了制件中纤维取向、强度、弹性模量及线膨胀系数等参数的差异对进气歧管力学性能的影响,得出了较为合理的纤维分布和最佳工艺参数组合,即4浇口,注射温度290℃,模具温度80℃,充填时间3。
补充资料：碳(石墨)纤维增强体(见碳纤维、石墨纤维)
碳(石墨)纤维增强体(见碳纤维、石墨纤维)
earbon(graPhite)fibrereinforeements
，、、里z耽维增强体earbon(graphi现inforcements用于复合材料中承受负荷，田的磷纤始知五史纤俯亡e)fibre起增强作
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条