1) Parameters of extrusion characteristics
挤出特性参数
2) extrusion parameter
挤出参数
3) extrusion characteristics
挤出特性
1.
Based on velocity and pressure fields calculated,the extrusion characteristics of tri-screw extruder,such as flow rate,back flow rate,mean shear rate,power consumption and productivity ratio,were calculated and compared wi.
通过速度和压力分布,计算了三螺杆挤出机的螺杆挤出特性参数,并和双螺杆挤出机进行对比分析。
2.
The extrusion characteristics of four-screw extruder,such as pumping capability,distributive mixing,dispersive mixing and productivity ratio,were calculated and compared with twin screw extrud.
利用计算所得的速度场和压力场,计算了四螺杆挤出特性,并和双螺杆、一字型排列和三角形排列的三螺杆挤出机进行了对比分析。
4) extrusion characteristic
挤出特性
1.
Based on above results,the post-processing program is employed to calculate the extrusion characteristics of tri-screw extruder.
利用速度场和压力场编制了后处理程序,计算了新型三螺杆反应器的挤出特性参数。
2.
The pressure, velocity and Viscosity distribution is discussed, and the extrusion characteristics of twin screw and tri-screw extruders are compared.
利用ANSYS软件包分析了聚乙烯在“一字”型排列三螺杆挤出机常规螺纹元件中的流动情况,讨论了整个流道的速度分布、压力分布、粘度分布,并和双螺杆挤出机常规螺纹元件的挤出特性进行了比较。
5) procession parameters
挤出工艺参数
6) characteristic parameter
特性参数
1.
Measurement and evaluation of the characteristic parameters of an image acquisition system;
图像采集系统特性参数的测试与评价
2.
Method for measuring the characteristic parameter of the circular polarization antenna
圆极化天线特性参数测量方法
3.
In order to obtain its non-static behavior properties and to compare the difference between static and non-static conditions,a new kind of analysis method which chooses characteristic parameters based on shape memory effect and super-elasticity was adapted to analysi.
为了获得非静态条件下的行为特性,比较静态和非静态条件下形状记忆合金的行为特性的差异,本文采用一种新的分析方法,即以形状记忆合金的特性参数为对象,来分析不同应变速率对形状记忆合金特性的影响。
补充资料：不完全挤出
不完全挤出：政府支出的增加只是被一种或多种私人支出的减少部分抵消.
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条