1) stretch bending
拉弯
1.
Numerical simulation study of spring back in stretch bending process for aluminum profiles;
铝型材拉弯回弹数值模拟研究
2.
FEM simulation technology on stretch bending of long profile with complex section;
大型异型材拉弯成形有限元模拟技术研究
3.
Mathematical mechanics analysis of stretch bending process;
拉弯工艺的数学力学分析
2) stretch-bending
拉弯
1.
Numerical simulation of a stretch-bending process for extruded aluminum rectangular tubes;
铝合金矩形管拉弯成形过程的数值模拟
2.
For the springback problem of sheet metal stretch-bending, a mathematical model was proposed based on Hill’s yielding criterion, exponential hardening and plane strain assumption.
基于平面应变假设,采用服从Hill平方屈服准则和指数强化材料模型,建立了板料拉弯成形回弹量预测的理论模型。
3) tension bending
拉弯
1.
In this paper, a correcting tension bending method through which the bending rebound of plate can be controlled is put forward, based on traditional tension bending method.
在传统的拉弯法基础上，提出了控制回弹的一种方法－－校正拉弯法。
2.
This paper sets up the plastic energy consumption and tensile functions of the ideal rigid plastic steel wire and lath under large curvature tension bending.
建立了理想刚塑性钢条、板条在大曲率拉弯过程中的塑性耗能量函数与拉力函数。
4) flexural-tensile
弯拉
1.
Anti-flexural-tensile strength test of semi-rigid type base course materials reinforced by geogrid;
土工格栅加筋半刚性基层材料的抗弯拉强度试验
2.
Experimental study of strain rate effect on dynamic flexural-tensile properties of wet sieving concrete in Xiaowan arch dam
小湾拱坝湿筛混凝土动态弯拉应变率效应试验研究
5) tension leveling line
拉弯矫
1.
Technical improvement of STAMCO tension leveling line cleaning and filtering system;
STAMCO拉弯矫清洗和过滤系统的技术改进
6) stretch bending forming
拉弯成形
1.
Simulation of stretch bending forming process of stainless section steel;
不锈钢型材拉弯成形工艺模拟研究
2.
Traditional stretch bending forming usually needs a rigid die to form a part.
传统的拉弯成形采用刚性拉弯模具的方法,由于拉弯零件数量多,因此需要大量的拉弯模具,且由于回弹的影响,修模工作量大、时间长、成本高。
补充资料：长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条