1) emulsifying wastewater
乳化废水
1.
Treatment of emulsifying wastewater from cold rolling with compound flocculent;
高浓度含油乳化废水的复合絮凝气浮处理
2.
Technology of treating emulsifying wastewater by electrolysis;
电解法处理乳化废水的技术研究
3.
In this paper,the Fenton oxidation process for the treatment of emulsifying wastewater was reported.
Ｆｅｎｔｏｎ 试剂是一种高效氧化剂，适用于难降解有机废水的处理；本文拟报道乳化废水的Ｆｅｎｔｏｎ 氧化处理过程；在常温下，投加与有机物相当量的双氧水与适量Ｆｅ２ ＋ ，ＣＯＤ去除率能够达到９０ ％ ，ＴＯＣ去除率达到８５ ％ 以上（原水ＣＯＤ５０ ５４０ ｍｇ／Ｌ，ＴＯＣ２１５２０ ｍｇ／Ｌ）。
2) emulsion wastewater
乳化废水
1.
Pretreatment process and its application of highly concentration and extra thick oil emulsion wastewater;
高浓度超稠油乳化废水预处理工艺与实践
2.
The treatment process for emulsion wastewater was conducted by using microwave irradiation technology.
采用微波辐射技术,对模拟乳化废水进行微波辅助化学破乳处理工艺研究。
3.
If discharged directly, emulsion wastewater could pollutes the environment seriously.
机械加工产生的乳化废水是一种高含油量、高COD的工业废水,直接排放会造成环境的严重污染,而且其稳定性很好,油/水分离后溶解性有机物难以通过化学和物理方法去除,很难实现达标排放。
3) emulsified wastewater
乳化废水
1.
A systematic study on wet air oxidation (WAO) of strength recalcitrant emulsified wastewater was performed in a 2-litre high-pressure batch autoclave, with emphasis on the influence factors and the dynamic characteristics.
在2L高压间歇反应釜中,系统地研究了高浓度难降解乳化废水的影响因素和动力学特征。
4) emulsion wastewater
乳化液废水
1.
The possibility of electrocoagulation treatment on cold rolling plant emulsion wastewater has been stud- ied.
研究了用电凝聚法处理冷轧乳化液废水的可行性,对比了直流电凝聚与交流电凝聚处理乳化液废水的效果,考查了直流条件下电流密度、电极间距、pH值、电凝聚时间等因素对COD、浊度去除效果的影响。
5) emulsified wastewater
乳化液废水
1.
Study of Fenton′s reagent and wet hydrogen peroxide oxidation for treatment of emulsified wastewater;
芬顿试剂和湿式过氧化氢氧化法处理乳化液废水研究
2.
A design example of the treatment of emulsified wastewater;
乳化液废水处理工程的设计实例
6) emulsification wastewater
乳化液废水
1.
Preparation and application of loaded catalyst on the process of catalytic wet air oxidation to emulsification wastewater;
乳化液废水催化湿式氧化处理工艺中的负载型催化剂的研制与应用
2.
This article studied the change of possible biochemistry and toxicity of emulsification wastewater before and after wet air oxidation and also studied the treating effect of wet air oxidation on emulsification wastewater after SBR process.
研究了乳化液废水湿式氧化前后的可生化性和生物毒性变化,并考察了SBR工艺处理湿式氧化后的乳化液废水的效果。
3.
According to the experimental results of homogenous catalytic oxidation of Cu salts of emulsification wastewater,it is found that the catalytic activity of single-metallic salts accords with: Cu(NO3)2 > MnSO4 >CoCl2.
乳化液废水的均相催化湿式氧化实验发现,单一金属盐催化活性:Cu(NO3)2>MnSO4>CoCl2。
补充资料：焦化厂含酚氰废水处理设计(见含酚氰废水处理设计)
焦化厂含酚氰废水处理设计(见含酚氰废水处理设计)
design of phenolic and cyanic waste water treatment for coking plant
J iaohuaehang honfenging feishui ehuli sheji焦化厂含酚氛废水处理设计(design of phe-nolie and eyanie waste water treatment foreoking plant)见含酚氛度水处理设计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条