1) tube
[英][tju:b] [美][tub]
列管
1.
The technical problems encountered by using the GH-Floating tube graphite heat exchange as evaporator have been demastrated.
采用GGH型新型列管式石墨蒸发器并选择适当的主要附件 ,应用于盐酸 -氯化亚铁蒸发浓缩过程 ,取得了良好的效
2.
This paper analyses effects and influence of an expansion joint on the deformation of the tubesheet, the bending moment of the tubesheet ,and the longitudinal stress of the tubes by means of numerical computation.
本文通过数值计算分析了固定式列管换热器加波形膨胀节后对管板变形、管板弯矩、列管轴向应力诸方面的综合效应与影响。
3.
This article presents the corrosion rule and characteristics of the HP heat exchanger tubes in urea plant and points the key for corrosion inspection of the tubes.
介绍尿素高压热交换器列管的腐蚀规律和特点，指明列管腐蚀检测的重点。
2) tubes
[英][tju:b] [美][tjub]
列管
1.
Summarizes the failure procedure of the waste heat boiler (WHB) of the secondary reformer in ammonia plant,analyzes the reasons for the perforation of the tubes,the leakage of the tube sheets as well as the leakage of WHB in hydraulic test,and presents solutions against the failure.
综述合成氨二段转化废热锅炉失效历程分析 ,废热锅炉列管穿孔、管板泄漏及水压试验泄漏的原因 ,提出解决对策。
2.
This paper analyses the mechanism and reasons for the fatigue damage of HP carbamate condenser tubes,explains the importance and necessity of controling tube vibration during the equipment operatio
分析甲铵冷凝器列管疲劳损伤产生的机理和原因 ,说明控制设备运行过程中列管振动的必要性和重要
3.
Presented the blasting of ammonium carbamate condenser tubes,analyzed the tube sample metallurgical structure,inner surface of the blasted tube as well as the micro-morphology of the fracture;made energy spectrum analysis to chemical composition of tube sample;calculated strength of heat exchanging tube;qualitatively analyzed reasons for tube blasting;and proposed effective preventive measures.
介绍甲铵冷凝器列管爆管情况,对取样管金相组织、爆破口内表面及其断口的微观形貌进行分析,对取样管的化学组成进行能谱分析,对换热管强度进行核算,定性分析列管产生爆管的原因,并提出有效的预防措施。
3) Pipe
[英][paɪp] [美][paɪp]
列管
1.
Reason on the heating pipe leak of recovery distillation kettle of NYLON - 6 monomer is analyzed.
分析了锦纶6单体回收蒸馏釜加热列管泄漏原因,且对蒸馏釜加热列管进行了改进,解决了蒸馏釜加热列管泄漏问题。
4) row tubes
列管
1.
The reasons for the leakage of high-pressured ammonia pre-heater row tubes and seals were explained, and how to handle and prevent the occurrence of similar accidents was proposed.
分析尿素装置高压氨预热器多次发生列管及封头泄漏的原因,提出如何处理及防止类似事故的发生。
5) vertical tube
列管
1.
5m 3 in volume with ellipsoidal bottom, by using a calorimetric method, the local heat transfer film coefficients on the outer surface of the vertical tubes used as baffles were measured with three types of impellers including CBY propeller, PBT and Rushton turbine.
5m3 的搅拌槽中 ,使用CBY螺旋桨、 4 5°斜叶桨和六直叶涡轮桨 ,对牛顿流体采用量热法 ,研究了列管外壁的局部传热膜系数的分布情况。
2.
Liquid crystal technique was used to measure the glycerin temperature distributions in an agitated tank heated by vertical tubes.
利用液晶测温技术测量了垂直列管加热的搅拌槽内甘油的温度场分布。
6) vertical tube
垂直列管
1.
Heat transfer for the liquid with low boiling-point in the vertical tube;
垂直列管内低沸点物料的沸腾传热
补充资料：错列管排
分子式：
CAS号：
性质：管束排列的一种方式，如图所示为错列管排。错列有等边三角形(图a)和正方形(图b)两种(图暂缺)
CAS号：
性质：管束排列的一种方式，如图所示为错列管排。错列有等边三角形(图a)和正方形(图b)两种(图暂缺)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条